Comnet CWFE1COAXM Manual de instalación y funcionamiento - Página 6
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Enrutador de red Comnet CWFE1COAXM. Comnet CWFE1COAXM 6 páginas. 100mbps ethernet-over-coax single / dual channel
Imprimir páginaMECHANICAL INSTALLATION INSTRUCTIONS
INSTALLATION CONSIDERATIONS
This modem is supplied as a Standalone module. Units should be
installed in dry locations protected from extremes of temperature and
humidity.
CAUTION: Take care not to press on any of the LEDs.
WARNING: Unit is to be used with a Listed Class 2 or LPS power supply rated
9-24 VDC, 12-24 VAC @ 120 mA.
FIGURE A
Dimensions are for the CWFE1COAXM standalone ComNet module
© 2011 Communications Networks Corporation. All Rights Reserved. "ComNet" and the "ComNet Logo" are registered trademarks of Communication Networks, LLC.
IMPORTANT SAFEGUARDS:
A) Elevated Operating Ambient - If installed in a closed or multi-unit rack
assembly, the operating ambient temperature of the rack environment may
be greater than room ambient. Therefore, consideration should be given to
installing the equipment in an environment compatible with the maximum
ambient temperature (Tma) specified by the manufacturer.
B) Reduced Air Flow - Installation of the equipment in a rack should be such
that the amount of air flow required for safe operation of the equipment is
not compromised.
FIGURE B
Dimensions are for a standard ComNet™ one slot module
3 CORPORATE DRIVE | DANBURY, CT 06810 | USA
T: 203.796.5300 | F: 203.796.5303 | TECH SUPPORT: 1.888.678.9427 | [email protected]
8 TURNBERRY PARK ROAD | GILDERSOME | MORLEY | LEEDS, UK LS27 7LE
T: +44 (0)113 307 6400 | F: +44 (0)113 253 7462 | [email protected]
.156 [3.96 mm]
.313 [7.95 mm]
INS_CWFE(1,2)COAX[M]_REV–
11/18/10
PAGE 6