Comnet CLFECOAX Manual de instalación y funcionamiento - Página 6

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Extensor Comnet CLFECOAX. Comnet CLFECOAX 9 páginas. Ethernet-over-coax extender with pass-through poe

Imprimir página

INSTALLATION AND OPERATION MANUAL

IP CAmERA-End

InsTALLATIOn (CLFE1COAX)

Set the Remote/Local dip switch to "Remote"

mode.

Set the S1 dip switch to the appropriate rate

S1 S2

based on the maximum data rate. OFF =

10Baset; ON = 100Baset

Set the S2 switch to "On" for Master.

For systems not utilizing PoE, connect the 12VdC or 24VAC

Power Supply to the power connector of the CLFE1COAX. An

external power adapter is provided to simplify connection.

If there is no external power source connected, the

CLFE1COAX will try to detect PoE.

CAUTION: If the external power adaptor is connected

with no power applied, the CLFE1COAX will not

recognize the PoE source and the system will be

inoperative.

Connect the IP camera RJ-45 connector to the 10/100Baset

Ethernet port of the CLFE1COAX using a standard Cat5/6

cable, 100m length (max).

Connect one end of the long coax cable to the BNC

connector of the CLFE1COAX.

TECh SUPPORT: 1.888.678.9427

EThERnET swITCh/nVR-End

InsTALLATIOn (CLFE(X)COAX)

Set the Remote/Local dip switch to "Local"

mode.

Set the S1 10/100Baset dip switch to the

S1 S2

appropriate rate based on the maximum

data rate. OFF = 10Baset; ON = 100Baset

Be sure the S2 switch to is set to "Off" for Slave.

Note: The 4, 8 and 16 channel units are preset to Slave/Local

mode. No adjustment required.

Connect the 12VdC or 24VAC Power Supply to the power

connector of the selected CLFE(X)COAX If there is no external

power source connected, the selected CLFE(X)COAX will try

to detect PoE.

Connect the IP camera RJ-45 connector to the 10/100Baset

Ethernet port of the selected CLFE(X)COAX using a standard

Cat5/6 cable, 100m length (max).

Connect one end of the long coax cable to the BNC

connector of the selected CLFE(X)COAX.

the Link LEd on the 10/100 Ethernet connector should be

"ON" to indicate proper connection between the switch and

the selected CLFE(X)COAX.

the traffic LEd on the Coax side should be "ON" and flashing

to indicate proper connection.

the Link LEd (Red for 100Baset, Green for 10Baset) will be "ON"

and not flashing to indicate confirmed connection between the

CLFE1COAX and selected CLFE(X)COAX extenders.

CLFE(X)COAX

INS_CLFEXCOAX_REV–

09/28/11

PAGE 6