Drehmo c-matic Manual de instrucciones - Página 3
Navegue en línea o descargue pdf Manual de instrucciones para Adaptador Drehmo c-matic. Drehmo c-matic 20 páginas. Usb-adaptor kit for actuators with integrated control unit
Imprimir página- 1. Connection on Matic C Base Plate DMC - 02 (Since Hw Rev. 5)
- 2. Connection on I-Matic Interface Unit DIM - 09 (Devicenet)
- 3. Connection on Matic C Display Unit DMC - 30 (Lcd Display Unit)
- 4. Connection on I-Matic Display Unit DIM - 02 (Ir / Irii)
- 5. Connection on I-Matic Interface Unit DIM - 17 (Modbus Loop)
1 General
1.1 Instructions
The following signs draw special attention to safety-relevant procedures in these operation
instructions:
This symbol signifies „additional information".
Failure to observe may lead to damage occurring.
This symbol signifies „attention".
Failure to observe may result in damage and personal injury.
This symbol signifies „warning!"
Failure to observe may result in damage and severe personal injury.
1.2 Validity
The usage of the described USB adaptor kit is only valid in combination with the DREHMO
specific electrical units as described in detail in the following sections. The adaptors offer a
mean to establish a serial connection between a PC with USB interface and various
intelligent electronic units.
1.2.1 Requirements
The usage of the USB adaptor kit is only allowed for trained staff. The knowledge of basic
electronic and electric rules is required.
A connection setup of the adaptor to the various electronic units is only allowed while
the units are not powered. Safety instructions of the actuator instruction manual and
the available electronic unit documentation have to be observed.
DREHMO
Instruction manual for USB adaptor kit
SERVICE
Service DREHMO GmbH
fon.: +49 2762 9850-206
fax: +49 2762 9850-210
page 3 of 20