Bosch Compact Rotary Hammer 11536C Manual de instrucciones de uso y seguridad - Página 10
Navegue en línea o descargue pdf Manual de instrucciones de uso y seguridad para Taladro Bosch Compact Rotary Hammer 11536C. Bosch Compact Rotary Hammer 11536C 45 páginas. Cordless hammer drill
También para Bosch Compact Rotary Hammer 11536C: Manual de instrucciones de uso y seguridad (45 páginas)
Imprimir página
BM 1619929800 01-08
1/8/08
9:39 AM
Page 10
INSTALLING & REMOVING ACCESSORIES
FIG. 6
3-JAW CHUCK
For small bits, open jaws enough to insert the
bit up to the flutes. For large bits, insert the bit
as far as it will go. Center the bit as you close
the jaws by hand. This positions the bit
properly, giving maximum contact between the
chuck jaws and the bit shank (Fig. 6).
To tighten chuck, insert key into each of the
three key holes in succession and tighten
clockwise firmly.
The chuck can be released by using one hole only.
Note: The 3-Jaw Chuck is for use only in "Drill
only" mode. The 3-Jaw Chuck is not for use
when drilling with hammering action.
AUXILIARY HANDLE
FIG. 7
The auxiliary handle will provide additional
control, support and guidance for the tool. The
WING KNOB
handle is adjustable around the 360° handle
collar mount.
To mount, loosen wing knob and slide handle
completely over chuck onto the collar mount
and tighten wing knob (Fig. 7).
AUXILIARY
HANDLE
DEPTH GAUGE
FIG. 8
Your drilling depth can be pre-set and/or
DEPTH GAUGE
repeated by using the depth gauge.
RELEASE LEVER
Setting depth: After the auxiliary handle is
installed, make sure the accessory has been
DEPTH GAUGE
fully inserted into the tool holder before setting
the depth gauge (Fig. 8).
To adjust depth, push down on the depth
gauge release lever, slide the depth gauge to
desired depth and release pressure on lever to
lock the depth gauge in place (Fig. 8).
-10-