Atkinson Electronics GSCM-mini-P Manual - Página 2
Navegue en línea o descargue pdf Manual para Unidad de control Atkinson Electronics GSCM-mini-P. Atkinson Electronics GSCM-mini-P 18 páginas. Generator start control module
Imprimir página
Table of Contents
Modes of Relay Operations
Typical Wiring Diagram
.........................................................
Option 2 Diagram
.........................................................
Option 3 Diagram
.........................................................
Option 1 Starting Sequence
Option 2 Starting Sequence
Option 3 Starting Sequence
..............................................................
Remote RV Generator Start Drawing
Outback Inverter/Inverter Style Drawing
Outback Inverter/Honda EUxx00is Drawing
Samlex America EVO Inverter Drawing
Limited Warranty
.....................................................
Solving your generators two to
three wire start-stop problem.
www.atkinsonelectronics.com
Circuit Board Division
800.261.3602
.........................................
..........................................
...............................................
........ .......................................
........................................
........................................
........................................
...............................
.........................................
.................
.............................
.................................
................
.........
....
.............
Not Included But.......
Outback 48 Volt inverter
systems require isolation relay
A0365
Features & Applications
Inexpensive 2 wire to 3 wire start controller for
electric push to start/stop Duel fuel generators
3
Optimized for use with Outback Invertors
3
Supports four manufactures generator control:
3
Champion, Cummins/Onan, Duramax and
Westinghouse
4
Fixed start/stop pulse times, accounts for
5
multiple start attempts by generator's ECU
5
Maximum auto-start run time limit (6 hours)
5
Remote run and fault indication included
6
ABS epoxy sealed for harsh environment
7
operation
8
9
Description
9
The GSCM-mini-P (Pulse) is a micro-processor based
10
generator start-stop module, designed to auto start-
10
stop generators that need a 3 to 4 wire connection
from a 2 wire 12 volt manual start command. The
11
GSCM-mini-P automatically goes into run mode
11
when it either receives a remote start indication
12
lamp signal (connected to terminal 8) or an AC Hz
13
signal from the generator (AC connected to terminals
14
9 & 10). Various LEDs are blinked or turned on to
indicated the run or fault status of the GSCM-mini-P.
15
Manually resetting the GSCM-mini-P by removing
16
the power and removes any lockout that allows the
generator to restart if called to do so.
The GSCM-mini-P is powered by 12VDC from the
generator battery and can monitor the battery
voltage and start the generator to charge its own
battery. The GSCM-mini-P is a limited function
controller that is part of the GSCM family.
All auto start battery voltage thresholds are
fixed, if adjustability is required use the GSCM
full function Generator Start Control Module.
2
Revised 02/21