Electrolux EGC3313 Manual del usuario - Página 13

Navegue en línea o descargue pdf Manual del usuario para Placa Electrolux EGC3313. Electrolux EGC3313 16 páginas. Electrolux hob
También para Electrolux EGC3313: Manual del usuario (16 páginas), Manual del usuario (16 páginas), Manual del usuario (20 páginas), Manual del usuario (20 páginas)

Imprimir página

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the by-

pass screw in.

• If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn (1/2 of

a turn for Triple Crown burner).

WARNING!

Make sure the flame does not go

out when you quickly turn the knob

from the maximum position to the

minimum position.

ELECTRICAL CONNECTION

• Ground the appliance according to safe-

ty precautions.

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the lo-

cal power supply.

• This appliance is supplied with a mains

cable. It has to be supply with a correct

plug, able to support the load marked on

the rating plate. The plug has to be fitted

in a correct socket.

• Any electrical component must be instal-

led or replaced by the Service Force

Centre technician or qualified service

personnel.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is an access to the

mains plug after installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• The appliance must not be connected

with an extension cable, an adapter or a

multiple connection (risk of fire). Check

that the ground connection is in con-

formity with the standard and regulations

force.

• The power cable must be placed in such

a way that it does not touch any hot

part.

• Connect the appliance to the mains with

a device that lets to disconnect the ap-

pliance from the mains at all poles with a

contact opening width of minimum 3

mm, eg. automatic line protecting cut-

out, earth leakage trips or fuse.

No part of the power cable must heat to a

temperature of more than 90° C.

Use clamps installed on the side of the

cabinet to prevent contact with the equip-

ment below the cooktop. See an example

of an optimal path in Figure.

Rigid copper pipe or flexible pipe in

stainless steel

REPLACEMENT OF THE

CONNECTION CABLE

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make

sure that the cable section is applicable to

the voltage and the working temperature.

The yellow/green earth wire must be ap-

proximately 2 cm longer than the brown (or

black) phase wire.

BUILDING IN

min. 650 mm

40-50 mm

55 mm

30 mm

If several 30 cm hobs are to be installed

side by side into the same cut out, an as-

sembly kit including a support side bracket

and supplementary seals is available at our

Service Centres. The relevant installation in-

structions are supplied within the kit pack-

age.

ENGLISH

490 mm

270 mm