Electrolux EGG9353 Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Placa Electrolux EGG9353. Electrolux EGG9353 16 páginas. 90cm wide stainless steelhob with 6 burners and cast iron pan supports.

Imprimir página

of gas you use (see table in "Techni-

cal Information" chapter).

Assemble the parts, follow the same

procedure backwards.

Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied

with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure ad-

juster on the gas supply pipe.

7.4 Adjustment of minimum level

To adjust the minimum level of the burn-

ers:

Light the burner.

Turn the knob on the minimum posi-

tion.

Remove the knob.

With a thin screwdriver, adjust the by-

pass screw position.

The by-pass screw

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the by-

pass screw in.

• If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn (1/2

of a turn for Triple Crown burner).

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

7.5 Electrical connection

• The electrical work necessary to install

the appliance must be done by a quali-

fied electrician or competent person,

according to the current regulations.

• The appliance must be earthed.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is access to the

mains plug after the installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• The appliance must not be connected

with an extension cable, an adapter or

a multiple socket. There is a risk of fire.

Make sure that the ground connection

complies with the standards and regu-

lations force.

• The power cable must not touch any

hot parts.

• The electrical installation must have an

isolation device which lets you discon-

nect the appliance from the mains at all

poles. The isolation device must have a

contact opening width of minimum 3

mm.

• You must have the correct isolation de-

vices: line protecting cut-outs, fuses

(screw type fuses removed from the

holder), earth leakage trips and contac-

tors.

• The connection cable parts must not be

heated to a temperature above 90°C.

Electrical Requirements

Permanent electrical installation must

comply with the latest I.E.E. Regulations

and local Electricity Board regulations. For

your own safety the installation must be

done by a qualified electrician (e.g. your

local Electricity Board, or a contractor

who is on the roll of the National Inspec-

tion Council for Electrical Installation Con-

tracting [NICEIC]).

The manufacturer declines any liabili-

ty if these safety measures are not

observed.

The appliance must be connected to a

230 V 50 Hz AC electrical supply.

Before activating the appliance, make

sure the electrical supply voltage is the

same as that indicated on the rating plate.

The rating plate is located on the bottom

of the appliance.

The appliance is supplied with a 3 core

flexible supply cord with a 3 amp plug. If it

is necessary to change the fuse, use a 3

amp ASTA-approved (BS 1362) fuse.

ENGLISH