Bosch GHO Professional 14 Manual del usuario - Página 9
Navegue en línea o descargue pdf Manual del usuario para Taladro Bosch GHO Professional 14. Bosch GHO Professional 14 34 páginas. Orbital sander
También para Bosch GHO Professional 14: Manual de instrucciones (31 páginas), Manual de instrucciones original (13 páginas), Manual de instrucciones original (13 páginas), Manual de instrucciones original (42 páginas), Manual de instrucciones original (45 páginas)
Imprimir página
20 | English
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
18.09.2009
Assembly
Battery Charging
Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The lithium ion battery is protected against
deep discharging by the "Electronic Cell Protec-
tion (ECP)". When the battery is empty, the ma-
chine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
Do not continue to press the
WARNING
On/Off switch after the ma-
chine has been automatically switched off. The
battery can be damaged.
2 609 932 657 | (15.10.09)
Dr. Eckerhard Strötgen
Head of Product
Certification
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
Observe the notes for disposal.
Removing the Battery
The battery 6 is equipped with two locking lev-
els that should prevent the battery from falling
out when pushing the battery unlocking button
5 unintentionally. As long as the battery is in-
serted in the power tool, it is held in position by
means of a spring.
To remove the battery 6, press the unlocking
button 5 and pull out the battery toward the
front. Do not exert any force.
Battery Charge-control Indication (only for
3.0 Ah battery) (see figure A)
The three green LEDs of the battery charge-con-
trol indicator 11 indicate the charge condition of
the battery 6. For safety reasons, it is only pos-
sible to check the status of the charge condition
when the machine is at a standstill.
Press button 10 to indicate the charge condi-
tion. This is also possible when the battery 6 is
removed.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
When no LED lights up after pushing button 10,
then the battery is defective and must be re-
placed.
Capacity
≥2/3
≥1/3
<1/3
Reserve
Bosch Power Tools