Andor Technology ACC-ASE-06969 Nota técnica - Página 2
Navegue en línea o descargue pdf Nota técnica para Cables y conectores Andor Technology ACC-ASE-06969. Andor Technology ACC-ASE-06969 3 páginas. Active camera link cable options for scmos platforms
Imprimir páginaActive Cable Setup
The following diagram illustrates the 'BitMaxx' 10 meter active Camera Link cable used in both ACC-ASE-06931
and ACC-ASE-06962.
Figure 1 – Active Cable used in both ACC-ASE-06962 and ACC-ASE-06962
The cable(s) only require a single power source which can be plugged into the power connector on the PC/Frame
Grabber end of each of the cables. A separate power supply unit and mains power lead is provided with the
cable(s).
When connecting the cable connectors care should be taken to ensure the correct orientation of the cable, as it has
a polarity thus can only operate in one orientation. The cable's end connectors are labelled "Frame Grabber" and
"Camera" respectively to indicate correct orientation. They are the same connector format as a standard Camera
Link cable. To mount, insert the ends into the appropriate socket and secure in place with their connector screws.
To ensure that the camera and cable operate correctly, the power up sequence below should be followed:-
1. Power up the active cable/s.
2. Turn the camera on.
3. Initialise the camera software.
Extended Input/Output BNC Lead.
The standard length of the I/O cable is 3 meters, supplied as standard with the camera system. If required, an
optional 10 meter I/O cable is available for both camera types:
Zyla: ACZ-05612_10m
Neo: ACZ-02991_10m
This cable provides the same connectivity and functionality as the standard 3 meter option.