andover SPINDECK Manual del producto - Página 7
Navegue en línea o descargue pdf Manual del producto para Plato giratorio andover SPINDECK. andover SPINDECK 16 páginas. Belt-drive turntable
También para andover SPINDECK: Manual del producto (12 páginas)
Imprimir páginaFit the Lid
Fit the lid (dust cover) carefully over the hinge prongs (pg.5, #10). The hinge tension is
pre-adjusted, however if the tension changes over time you may adjust the screws until
the lid stays open where you want it to without being too stiff to open or close.
Remove the Stylus Protection Cover
Carefully remove the clear plastic stylus protection cover by gently pulling it straight off
the front of the stylus. Save it for later use if Spindeck must be moved or shipped. Take
care to not pull the stylus out in the process.
Connect it to Power
The turntable is supplied with a power adapter. Plug the power adapter into the DC
power jack at the rear of Spindeck first, then plug the adapter into your AC power.
Turn it On
Use the power switch on the left side of the plinth (pg.5, #1) to start and stop the motor.
To Change Playing Speed
For 33RPM operation, place the belt on the upper (smaller) section of the motor pulley.
(pg.5, #2)
For 45RPM operation, use the lower (larger) section of the pulley.
Always switch the motor OFF before changing the belt position.
Cartridge Tracking Force Adjustment
There is no need to make any adjustments to the tonearm when using the supplied
Ortofon OM5e cartridge. The counterweight is pre-set perfectly from the factory.
If you switch to another make or model cartridge, or if your counterweight is moved,
you will have to reset the tonearm. The counterweight (pg.5, #8) supplied is suitable for
cartridges weighing between 3 - 7g.
If you change your cartridge, please read Installing a New Cartridge on page 12.
Maintenance and Cleaning
Your record player requires little or no regular maintenance. Remove dust with a slightly
moistened antistatic cloth. Never use a dry cloth because this will create static electricity
which will attract more dust! Antistatic cleaning fluids are available at specialist stores
but must be applied sparingly to avoid damage to rubber parts. To avoid damage it is
recommended to fit the stylus cover before cleaning or maintenance is carried out.
If the player is not used over a long period of time, the drive belt should be removed to
prevent unequal stretching.
Page 7