Compac HP60 G2 Manual de instrucciones - Página 5
Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Compac HP60 G2. Compac HP60 G2 13 páginas. Presses datelier
Imprimir páginaUse of the hydraulic Compac press:
The hydraulic press may be damaged if the following instructions for the use of this press are not fol-
lowed. Any damage that occurs from wrong use is not covered by warranty.
The item which is inserted into the press should always be supported correctly, this means that
the item should be stable and it should not be able to move during the compression phase.
The press must constantly during the whole compression phase be able to make a vertical pressure.
As a general protection of the stuffing box, piston and cylinder, it is recommended to use the shortest
possible length of stroke. This can be obtained by lifting the press table as close to the returned piston as
possible. This will decrease the risk of excess sideways pressure on the piston and increase the ex-
pected service life of the press.
Warning! If the above instructions are ignored, there will be a great risk of person injury and damaging of
the press.
Maintenance and service:
Drain the water separator regularly by turning the plug at the bottom of the water separator.
When emptying the water separator turn counter clockwise, and remember to fasten the plug after empty-
ing.
A lack of emptying the water separator will cause corrosion of the piston and cylinder.
Errors occurred by lack of emptying the water separator is not covered by warranty.
The cylinder and the pump are self-lubricating.
All moveable parts are lubricated as needed.
Oil Change is needed every 1 to 2 years.
The press must be filled with hydraulic oil - Castrol type Hyspin AWS22 (viscosity 22 at 40°C) or any
equivalent oil specification.
Oil Change:
Remove the oil plug on the oil tank. Drain the oil and fill it with new oil (see oil specification).
When changing the oil it is important that no impurity gets into the pump, this can
cause damage to the hydraulic system.
Model:
HP40, HP50
HP60, HP70
Oil specification:
Castrol Hyspin AWS 22 or any equivalent hydraulic oil from other suppliers.
Spare parts:
Please look for the spare parts drawing on our webpage
Decommissioning:
approved receiving station.
HP-FP-40 G2-50 G3-60 G2-70 G2 (GB) V 1.1
Oil Volume
Oil level
5,5 L
70 mm
100 mm
9 L
When disposing of the press. Drain the hydraulic oil and hand it over to an
4/3
www.compac.dk
13-08-2015 SN/PD