Andover Controls Infinity ACC EMX 151 Manual de instalación - Página 3

Navegue en línea o descargue pdf Manual de instalación para Unidad de control Andover Controls Infinity ACC EMX 151. Andover Controls Infinity ACC EMX 151 4 páginas.

Imprimir página

Caution

Remember that the current sources to ground.

1.Slip the appropriate wire under the I screw and tighten

the screw down on it.

Figure 5 illustrates the wiring for current outputs.

2.Slip the ground wire under the RET screw and tighten

the screw down on it.

Figure 5. Wiring Diagram for Current Outputs

RET

Warning

This equipment has been tested and found to comply

with the limits for a Class A digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interfer-

ence when the equipment is operated in a commercial

environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and

used in accordance with the instructions in this manual,

may cause harmful interference to radio communica-

tions. Operation of this equipment in a residential area

is likely to cause harmful interference in which case the

user will be required to correct the interference at his

own expense.

Technical Manuals Online! - http://www.tech-man.com

Click for EMX Menu

RL < or = 750 Ω

EMX 151 Installation Guide-3

firealarmresources.com

Adjust the Outputs

and Troubleshoot

For information on how to assign output numbers, see the

Andover Controls Infinity CX Programmer's Guide.

If you have problems with the Infinet controller after in-

stalling the module, see the Andover Controls Infinet

Controller Troubleshooting Guide.

Refer to the EnergyNet and Infinet Configuration Guide

for information on how to troubleshoot network and pow-

er supply problems.

Note

This digital apparatus does not exceed the Class A limits

for radio noise emissions from digital apparatus set out

in the Radio Interference Regulations of the Canadian

Department of Communications.

Avis

Le présent appareil numérique n'émet pas de bruits ra-

dioélectriques dépassant les limites applicables aux

appareils numériques de la class A prescrites dans le Rè-

glement sur le brouillage radioélectrique édicté par le

ministère des Communications du Canada.