3M W-3197 Instrucciones de uso - Página 10
Navegue en línea o descargue pdf Instrucciones de uso para Equipos de seguridad 3M W-3197. 3M W-3197 15 páginas. Air regulating kit
10. Bring the free end of the shoulder strap across the back, over the left shoulder and down across your chest
to the female end of the belt buckle. (Fig. 5)
11. Snap the loop end of the shoulder strap just to the right of the female end of the belt buckle. This limits
the shoulder strap from sliding left past the buckle. Adjust the strap as required, tucking any extra strap
under the belt keeper on the shoulder strap. (Fig. 6)
12. Position the breathing tube across the back and over the right shoulder. If the top shoulder strap loop
makes this difficult to do because the top snap loop ends up on the front, or on the top of the shoulder,
unsnap it and tuck it under the shoulder strap next to your body. An unused top shoulder strap loop may
also be removed, if you are careful not to damage the shoulder strap. After all adjustments are made, the
highest loop that the breathing tube goes through should be positioned on your back approximately
between the shoulder blades.
Note: Positioning the breathing tube and shoulder strap over opposite shoulders will keep the breathing tube
close to the body, and helps to not restrict head movements. It is also beneficial for the breathing tube to go
over the right shoulder, so any upward shoulder movements then tend to tighten the air supply connection to
the facepiece, instead of loosening that connection.
13. The W-3188 breathing tube should then be connected to the W-3187 adapter. Assure the connection is
tight and secure. The W-3187 connection to the facepiece should always be tight enough that a slight tug
or push on the breathing tube will not loosen the connection of the air supply to the full facepiece.
14. Put on the facepiece. Make sure that the breathing tube does not tug or push on the facepiece. Normal
head movement should not compromise the facepiece seal. If it does, the shoulder strap attachments
should be readjusted, so that any tugging or pushing is minimized.
Fig. 5
Fig. 6
10