Electrolux 30" Electric/Microwave Combination Wall Oven Manual de instrucciones de instalación - Página 6

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Campana de ventilación Electrolux 30" Electric/Microwave Combination Wall Oven. Electrolux 30" Electric/Microwave Combination Wall Oven 21 páginas. Gas cooktop
También para Electrolux 30" Electric/Microwave Combination Wall Oven: Manual de instalación (16 páginas), Manual de instalación, uso y mantenimiento (22 páginas), Manual de instrucciones de instalación (28 páginas), Manual de uso y mantenimiento (36 páginas), Manual de instrucciones de instalación (25 páginas)

GAS COOKTOP INSTALLATION INSTRUCTIONS

(For 30" Models with 4 Sealed Burners, And Optional Electric Built-In Oven Combination)

Wall Outlet Location

Figure 4

Clamp Down Information

Once the cooktop is installed in the counter opening, you

must clamp the unit down as shown.

Figure 5

To clamp down, insert the bracket with the offset side of

the angle into the slots on each side of the unit. The

thumb screw should then be run through the bracket, up

against the bottom of the counter. Tighten until the unit

draws down.

This cooktop is designed to operate on natural gas at 4"

of manifold pressure only.

A pressure regulator is connected in series with the

manifold on the cooktop and must remain in series with

the supply line.

For proper operation, the maximum inlet pressure to

the regulator must be no more than 14" of water column

(W.C.) pressure.

For checking the regulator, the inlet pressure must be at

least 1" (or 2.5 kPa) greater than the regulator manifold

pressure setting. The regulator is set for 4" of manifold

pressure, the inlet pressure must be at least 5".

The gas supply line to the range should be 1/2" or 3/4"

pipe.

LP/Propane Gas Conversion

This appliance can be used with Natural gas or LP/

Propane gas. It is shipped from the factory for use with

natural gas.

A kit for converting to LP gas is supplied with your

cooktop. The kit is marked "FOR LP/PROPANE GAS

CONVERSION".

The conversion must be performed by a qualified service

technician in accordance with the kit instructions and all

local codes and requirements. Failure to follow

instructions could result in serious injury or property

damage. The qualified agency performing this work

assumes responsibility for the conversion.

Failure to make the appropriate

conversion can result in personal injury and property

damage.