Electrolux 36" Ceramic Manual de instrucciones de instalación - Página 7

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Campana de ventilación Electrolux 36" Ceramic. Electrolux 36" Ceramic 25 páginas. 30” and 36” free-standing range hood
También para Electrolux 36" Ceramic: Manual de uso y mantenimiento (26 páginas), Manual de instrucciones de instalación (7 páginas), Manual de instalación, uso y mantenimiento (22 páginas), Manual de instrucciones de instalación (8 páginas)

Imprimir página

GAS COOKTOP INSTALLATION INSTRUCTIONS

Check Operation

Refer to the Use and Care Guide packaged with the

cooktop for operating instructions and for care and

cleaning of your cooktop.

Do not touch the burners. They may be

hot enough to cause burns.

1. Burner Bases and Burner Caps

This range is equipped with sealed burners as shown

(Figure 8). All pieces are at their place. Take note where

they are. Remove all packaging material located

under the Dual Surface burner head. Make sure the

burner is properly aligned and leveled.

NOTE: There are no burner adjustments necessary on

this range.

2. Turn on Electrical Power and Open Main Shutoff

Gas Valve

3. Check the Igniters

Operation of electric igniters should be checked after

range and supply line connectors have been carefully

checked for leaks and range has been connected to

electric power. To check for proper lighting:

a. Push in and turn a surface burner knob to the LITE

position. All electronic surface ignitors will spark at the

same time. However, only the burner you are turning

on will ignite.

b. The surface burner should light once the flow of gas

reached the surface burner. Each burner should light

within four (4) seconds in normal operation after air

has been purged from supply lines. Visually check that

burner has lit.

c. Once the burner lights, the control knob should be

rotated out of the LITE position.

There are separate ignition devices for each burner. Try

each knob separately until all burner valves have been

checked.

Figure 8

4. Adjust the "LOW" Setting of Regular Burner (see

figure 8) on the Surface Burner Valves (Figure 9):

a. Push in and turn control to LITE until burner ignites.

b. Quickly turn knob to LOWEST POSITION.

c. If burner goes out, reset control to OFF.

d. Remove the surface burner control knob and

decorative ring.

e. Insert a thin-bladed screwdriver into the hollow valve

stem and engage the slotted screw inside. Flame

size can be increased or decreased by turning the

screw. Turn counterclockwise to increase flame size.

Turn clockwise to decrease flame size. Adjust flame

until you can quickly turn knob from LITE to LOWEST

POSITION without extinguishing the flame. Flame

should be as small as possible without going out.

Note: Air mixture adjustment is not required on surface

burners.

Figure 9