Bosch 2 Manual de instrucciones - Página 6

Imprimir página

Operating modes

ÇOperating modes

E xhaust air mode

O p e r a t i n g m o d e s

The air which is drawn in is cleaned

by the grease filters and conveyed to

the exterior by a pipe system.

The air must not be discharged into a flue that is

Note:

used for exhausting fumes from appliances burning gas

or other fuels (not applicable to appliances that only

discharge the air back into the room).

Before conveying the exhaust air into a non-

■

functioning smoke or exhaust gas flue, obtain the

consent of the heating engineer responsible.

If the exhaust air is conveyed through the outer wall,

■

a telescopic wall box should be used.

Air recirculation

The air which is drawn in is cleaned by

the grease filters and an activated

carbon filter, and is conveyed back into

the kitchen.

To bind odours in air recirculation mode, you

Note:

must install an activated carbon filter. The different

options for operating the appliance in air recirculation

mode can be found in the brochure. Alternatively, ask

your dealer. The required accessories are available

from specialist retailers, from customer service or from

the Online Shop.

1Operating the appliance

T hese instructions apply to several appliance variants.

O p e r a t i n g t h e a p p l i a n c e

It is possible that individual features are described

which do not apply to your appliance.

Switch on the extractor hood when you start

Note:

cooking and switch it off again several minutes after you

have finished cooking. This is the most effective way of

removing the kitchen fumes.

Fold the glass cover forwards. This increases the

Note:

extraction area.

Control panel

1: Lighting

Switches off the lighting

Switches on the lighting

2: Fan

Switches off the fan

Switches on fan setting 1

Switches on fan setting 2

Switches on fan setting 3

Setting the fan

Always adjust the fan strength to meet current

Note:

conditions. If there is a large build-up of steam or

fumes, select a high fan setting.

Switching on

Set the slide control to position 1, 2 or 3.

Switching off the appliance

Set the slide control to position 0.

Lighting

The lighting can be switched on and off independently

of the ventilation.

Set the slide control to position 1.