Bosch 6 Series Manual de instrucciones - Página 6

Imprimir página

Operating the appliance

Note: Switch on the extractor hood when you start cooking and

switch it off again several minutes after you have finished

cooking. This is the most effective way of removing the kitchen

fumes.

Control panel

Explanation

Fan off/fan level 1

Fan level 2

Fan level 3/intensive mode

Light on/off

Setting the fan

Switching on

Press the

, 2 or 3/

button.

Note: The LED indicates which fan level is currently set:

Cleaning and maintenance

Risk of burns!

The appliance will become hot during operation, especially

near the bulbs. Allow the appliance to cool down before

cleaning.

Risk of electric shock!

Penetrating moisture may result in an electric shock. Clean the

appliance using a damp cloth only. Before cleaning, pull out the

mains plug or switch off the circuit breaker in the fuse box.

Risk of electric shock!

Do not use any high-pressure cleaners or steam cleaners,

which can result in an electric shock.

Risk of injury!

Components inside the appliance may have sharp edges. Wear

protective gloves.

Cleaning agents

To ensure that the different surfaces are not damaged by using

the wrong cleaning agent, observe the information in the table.

Do not use any of the following:

Harsh or abrasive cleaning agents,

■

Cleaning agents with a high alcohol content,

■

Hard scouring pads or cleaning sponges,

■

High-pressure cleaners or steam cleaners.

■

Wash new sponge cloths thoroughly before use.

Follow all instructions and warnings included with the cleaning

agents.

Level 1: LED lights up green.

■

Level 2: LED lights up orange.

■

Level 3: LED lights up red.

■

Switching off

Press the

button.

Note: If fan level 2 or 3 is switched on, press the

twice.

Intensive setting

You can use the intensive setting if there is a large build-up of

odours and fumes/vapours.

Press and hold the 3/

button.

Intensive mode is activated. The LED flashes red.

Notes

The intensive mode run time is limited to 6 minutes.

■

Once 6 minutes has elapsed, the appliance switches back to

■

the fan level that was previously selected.

Intensive mode can be activated when the appliance is

■

switched off; once 6 minutes has elapsed, the appliance

switches itself off again.

Lighting

Press the

button.

Note: The lighting can be switched on and off independently of

the ventilation system.

Area

Cleaning agent

Stainless steel

Hot soapy water:

Clean with a dish cloth and then dry

with a soft cloth.

Clean stainless steel surfaces in the

grind direction only.

Special stainless steel cleaning prod-

ucts are available from our after-sales

service or from specialist retailers.

Apply a very thin layer of the cleaning

product with a soft cloth.

Painted surfaces

Hot soapy water:

Clean using a damp dish cloth and dry

with a soft cloth/towel.

Do not use any stainless steel cleaners.

Aluminium and plas-

Glass cleaner:

tic

Clean with a soft cloth.

Glass

Glass cleaner:

Clean with a soft cloth. Do not use a

glass scraper.

Controls

Hot soapy water:

Clean using a damp dish cloth and dry

with a soft cloth/towel.

Risk of electric shock caused by pene-

trating moisture.

Risk of damage to the electronics from

penetrating moisture. Never clean

operating controls with a wet cloth.

Do not use any stainless steel cleaners.

button