Bosch 6 Series Información de uso - Página 13

Imprimir página

Fault

⁠ ⁠

⁠ ⁠ and the heat set-

ting flash alternately.

A signal sounds.

⁠ ⁠ and audible signal Hot pot near the control panel. The hotplate has been switched off to protect the electron-

⁠ ⁠

⁠ ⁠ and hotplates do

not heat up

A message with "E"

appears on the dis-

play, e.g. E0111.

15 Disposal

15.1 Disposing of old appliance

Valuable raw materials can be reused by recycling.

Dispose of the appliance in an environmentally

▶

friendly manner.

Information about current disposal methods are

available from your specialist dealer or local author-

ity.

16 Customer Service

Function-relevant genuine spare parts according to the

corresponding Ecodesign Order can be obtained from

Customer Service for a period of at least 10 years from

the date on which your appliance was placed on the

market within the European Economic Area.

Note: Under the terms of the manufacturer's warranty

the use of Customer Service is free of charge.

Cause and troubleshooting

Several hotplates have been used over a prolonged period at high power settings. The hot-

plate has been switched off to protect the electronics.

Wait a while.

Touch any touch field.

a When the message no longer appears, the electronics have cooled down sufficiently.

You can continue to cook.

Despite being switched off by ⁠ ⁠ , the electronics have become hot again. All hotplates

have therefore been switched off.

Wait a while.

Touch any touch field.

a When the message no longer appears, the electronics have cooled down sufficiently.

You can continue to cook.

Hot pot near the control panel. There is a risk that the electronics will overheat.

Remove the pan.

▶

a The display goes out shortly afterwards.

ics.

Remove the pot.

Wait a while.

Touch any touch field.

a When the message no longer appears, the electronics have cooled down sufficiently.

You can continue to cook.

The hotplate was on for too long and has switched off automatically.

You can switch the hotplate back on again immediately.

Demo mode is activated.

Disconnect the appliance from the power supply for 30 seconds by briefly switching off

the circuit breaker in the fuse box.

Touch any touch field within the next three minutes.

The electronics have detected a fault.

Switch the appliance off and on again.

a If the fault was a one-off, the message disappears.

If the message appears again, call the after-sales service. Please specify the exact error

message when calling.

→ "Customer Service", Page 13

This appliance is labelled in accord-

ance with European Directive

2012/19/EU concerning used elec-

trical and electronic appliances

(waste electrical and electronic equip-

ment - WEEE).

The guideline determines the frame-

work for the return and recycling of

used appliances as applicable

throughout the EU.

Detailed information on the warranty period and terms

of warranty in your country is available from our after-

sales service, your retailer or on our website.

If you contact Customer Service, you will require the

product number (E-Nr.) and the production number

(FD) of your appliance.

Disposal en