Atlantic MD250 Manual del producto - Página 3

Navegue en línea o descargue pdf Manual del producto para Bomba de agua Atlantic MD250. Atlantic MD250 17 páginas. Md-series
También para Atlantic MD250: Manual de instrucciones (6 páginas)

Imprimir página

• CAUTION:

THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.

• WARNING:

RISK OF ELECTRIC SHOCK - THIS PUMP IS SUPPLIED WITH A GROUNDING CONDUCTOR AND

GROUNDING-TYPE ATTACHMENT PLUG. TO REDUCE THE RISK OF ELECTRIC SHOCK, BE CERTAIN

THAT IT IS CONNECTED ONLY TO A PROPERLY GROUNDED, GROUNDING TYPE RECEPTACLE.

Electrical Safety

• Electrical wiring should be installed by a qualified electrician in accordance with all

applicable safety regulations. Incorrect wiring can lead to a pump malfunction, electrical

shock or fire.

• Pumps should operate on a designated, 110/120 volt circuit.

• Pump must be protected by a ground fault circuit interrupter (GFCI).

• Pump must be plugged into a standard, properly grounded, three pronged outlet.

Safety Instructions

• Do not lift, lower or handle the pump by pulling on the electrical cord. Make sure the

electrical cable does not become excessively bent or twisted and does not rub against a

structure in a way that might damage it. (Fig. 1)

• Always disconnect the power supply before doing any maintenance or placing your hands

into the water to which this pump is immersed. (Fig. 2)

• The submersible pump should not be used if the electrical supply cable is damaged in any

way. If a cable with damaged insulation is submerged in water, there is danger of water

seeping into the pump motor and causing a short. The electrical cable cannot be replaced.

If the cord is damaged, the pump should be discarded. Altering the electrical cable in any

way will void the warranty. (Fig. 3)

ATTENTION

Operation

• Mag Drive Series pumps are for use in water only. Water temperature should never

exceed 95˚ F (35˚ C).

• Mag Drive Series pumps must not be used to pump salt water, sewage, flammable or

corrosive liquids, greases, oils or food waste.

• Pay careful attention to the water level while the pump is operating. The pump must be

fully submersed at all times of operation.

Make sure the pump works at a proper water level. Do not

operate the pump without water. If so, the pump should be

turned off immediately and check.

Fig. 1

Fig. 2

Fig. 3