Electrolux FHWC3055LSA Manual de uso y mantenimiento - Página 6
Navegue en línea o descargue pdf Manual de uso y mantenimiento para Campana de ventilación Electrolux FHWC3055LSA. Electrolux FHWC3055LSA 13 páginas. 30 and 36 free-standing range hood
También para Electrolux FHWC3055LSA: Manual de uso y mantenimiento (13 páginas), Manual de uso y mantenimiento (13 páginas)
Imprimir página
6
Installing the hood
Installing the hood
IMPORTANT
We recommend that two people carry
out the installation. Pay attention to the
procedure described in the assembly
instructions.
Preparation
•
Determine the exact location of the range hood.
•
Plan the route for venting exhaust to the outdoors
) .
•
Plan the power connection prior to installation so
that electrical wiring will not be visible afterwards.
House wiring location: The junction box is
•
located on the top right side of the hood. Wiring
should enter the back wall at least 20" above
the bottom of the installation height, and within
3-3/8" to 4-3/4" of the right side of the centerline
/
) .
fig.
3-1/4" circle
6-1/4" dia. hole
•
Use the shortest and straightest duct route
possible.
• The
wall
out by a professional prior to installing the
range hood. Pay attention to the length of
the exhaust hose when planning the wall
breakthrough. The exhaust hose must reach
h t
e
o
t u
r e
Important! If the exhaust hose leads through an
outer wall, install a wall cap with damper or roof
cap at the exterior opening (not delivered). This
can be installed by the professional that performs
the wall breakthrough.
GB
• If open
breakthrough
must
e
d
g
e
f o
h t
e
w
l l a
i w
h t
o
t u
are operated in the same room,
ask your local chimney sweeper about the local
regulations prior to installation.
• If you are renting, then approval must be obtained
from the owner of the property.
• Attention! In order for the range hood to reach
optimal performance, install it over the middle of
the cooking area.
• The following accessories are required to mount
the range hood (not included):
Exhaust duct
Power drill with 3/16" and 1/8" bits
Screwdriver
Level
Cable detector
Measuring tape
Duct tape
fig.
Ducting installation guidelines
• For safety reasons, ducting should vent directly
outdoors (not into an attic, underneath the house,
into the garage or into any enclosed space).
• Keep duct runs as short and straight as possible.
• Duct
•
Back to back elbow and "S" turns give very poor
be
carried
delivery and are not recommended.
•
A short straight length of duct at the inlet of the
remote blower gives the best delivery.
•
Transition to duct from the integral blower or
remote duct transition as close to the downdraft
a
n
y
k
n i
k
. s
as is possible.
•
Use a suitable 6" round duct.
•
Flexible metal round ducts should only be used
when no other duct
short lengths and do not crush when making
corners.
8 to 9
ft
Installation
height
36"
(elbows and transitions) reduce air
exists. Limit use to
Center line