Electrolux FHWC3655LSA Manual de uso y mantenimiento - Página 12
Navegue en línea o descargue pdf Manual de uso y mantenimiento para Campana de ventilación Electrolux FHWC3655LSA. Electrolux FHWC3655LSA 13 páginas. 30 and 36 free-standing range hood
También para Electrolux FHWC3655LSA: Manual de uso y mantenimiento (13 páginas), Manual de uso y mantenimiento (13 páginas)
12
Troubleshooting
IMPORTANT
Clean the filter every month to prevent risk of
fire.
Maintenance
• User servicing – Do not repair or replace
any part of the appliance unless specifically
recommended in the manual. All other servicing
should be referred to a qualified technician.
Light bulb replacement
• Switch the appliance off and disconnect the
power supply.
• In order to replace the light bulb (7), the metallic
anti-grease filter should be detached first.
• Pull the spring lock downward (fig. ).
• Rotate and pull one or both of the light bulbs from
the holders and replace with new light bulb(s) of
the same type (GU10, 20W, 120V~) (fig. / ).
• Replace the metallic anti-grease filter and make
sure it locks in place.
fig.
fig.
Technical data
Power supply
Power consumption
Bulb type
Power cable type
GB
fig.
fig.
:
120V~, 60Hz
:
520W
:
2x 20W, 120V~
(type: GU10)
:
18AWG
(Amer. Wire Gauge)
300V~, 105˚C
Troubleshooting
Problem
Cause
The appliance
is not fixed
properly on the
brackets.
Excessive
The fan blade
vibration.
is damaged.
The fan motor
is not fixed
tightly.
The fan blade
Light on, but
is jammed.
fan does not
The motor is
work.
damaged.
Light bulb
broken.
Both light and
fan do not
Problem with
work.
electrical
connection
Distance
between the
appliance and
the cooking
Suction
place too
performance
large.
is not good.
Metallic anti-
grease filter is
dirty.
Environmental protection
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check
with your Local Authority or retailer for
recycling advice.
Solution
Take down
the appliance
and check it is
properly fixed.
Switch off the
appliance.
Repair to be
carried out by
qualified service
personnel only.
Replace with
a bulb with
correct rating.
Check the
electrical
connection with
an electrician.
Readjust the
distance (page
7, fig.
and
table below)
Clean
filters (see
Cleaning and
maintenance).