Electrolux HOOS11E Manual del usuario - Página 16
Navegue en línea o descargue pdf Manual del usuario para Campana de ventilación Electrolux HOOS11E. Electrolux HOOS11E 24 páginas. Built-in hood for electric oven
También para Electrolux HOOS11E: Manual de instalación (32 páginas)
F.2
Appliance cleaning
The oven has special cleaning programs; a pop-up
window automatically appears when maintenance is
required.
NOTE!
To ensure best cleaning results, and to
protect the hood with the cleaning
programs, neutral detergents must be
used.
F.2.1
Labyrinth Filters cleaning
The labyrinth filters are located in front of the hood.
Periodic cleaning is recommended.
1.
Remove the labyrinth filters, starting from the
middle one, raising (1) and pulling the lower part
outwards (2);
2.
Wash with hot water and neutral detergent
using a nozzle; if necessary, use a soft brush or
place it in a dishwasher and select a gentle
program.
3.
Rinse in hot water, shake well and allow to
drain.
4.
Refit the labyrinth filters. Make sure to refit them
properly.
F.2.2
External and internal cleaning
•
Clean the stainless-steel parts every day using
lukewarm soapy water;
•
Rinse with plenty of water and dry thoroughly;
•
Do not clean the stainless steel with steel wool,
brushes or scrapers in common steel, as they
could deposit ferrous particles which oxidise,
causing rust spots;
•
Whenever the appliance is not used for long
periods:
-
Disconnect the power supply. Turn off the
water taps;
-
Go over all steel surfaces vigorously with a
cloth moistened with paraffin oil in order to
create a protective film;
-
Periodically air the premises.
F.2.3
Demister and Water Separator Filter
cleaning
The hood is equipped with a Demister and Water
Separator Filter. It is located inside a left technical
compartment, behind the Labyrinth Filter, in front of
the hood.
Periodic cleaning is recommended
1.
Remove the labyrinth filters, starting from the
middle one, raising and pulling the lower part
outwards (see F.2.1);
2.
Open the left technical compartment by undoing
the screws fixing the cover;
3.
Remove the Demister and Water Separator
Filter; use gloves, paying attention to their
load/weight;
4.
For thorough cleaning, place the Demister and
Water Separator Filter, in a basin with hot water
and neutral detergent;
5.
Leave immersed for 24/48 hours to remove the
sticky particulate;
6.
Wash with hot water;
7.
Rinse in hot water;
8.
The Demister Filter must be perfectly dry before
reusing it; if necessary, leave in a dry place for
24/48 hours;
9.
Refit the Demister and Water Separator Filter
using the relevant guides. Make sure to refit
them properly;
10. Close left technical compartment with cover
using the screws;
11. Refit the labyrinth filters. Make sure to refit them
properly.
231007 OM_HO_04_ELUX_EN.docx -
16