Atlantic Ultraviolet MIN-6 Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Sistemas de filtración de agua Atlantic Ultraviolet MIN-6. Atlantic Ultraviolet MIN-6 16 páginas. Germicidal ultraviolet water purifiers
También para Atlantic Ultraviolet MIN-6: Manual del usuario (16 páginas), Manual del usuario (20 páginas)

Imprimir página

TROUBLESHOOTING

CAUTION:

IMPORTANT: This unit is to be serviced ONLY by qualified, and appropriately licensed, personnel.

Problem

Purifier not operating.

Water leaking into/from

purifier.

Poor purifier performance

Always disconnect power to the water purifier, before performing any service.

Table 2 - Troubleshooting

Possible Cause

No electrical power...

Ballast Lamp-out

Protection . . .

Cracked or broken

quartz sleeve...

Quartz sleeve sealing

o-ring (s) worn, damaged...

Poor, or loose, connections

or fittings...

Quartz sleeve fouled...

Germicidal lamp output

depreciating...

Germicidal lamp not

functioning...

Low input voltage...

Change in water quality...

Corrective Action

Verify that the purifier is connected to a

live power source.

Disconnect the purifier from utility power. Replace lamp.

The purifier must remain disconnected from power for

two (2) minutes to reset.

Shut down purifier, drain, and replace quartz sleeve.

See "Quartz Sleeve Cleaning or Replacement" in the

"Maintenance" section.

Shut down purifier, drain, and remove static gland nut,

replace sealing o-ring. See "Quartz Sleeve Cleaning or

Replacement" in the "Maintenance" section.

Tighten suspect connection or fitting; or shut down

purifier, drain, and remove fitting or connection.

Clean threads; reapply thread sealing tape and reinstall.

Clean quartz sleeve, see "Quartz Sleeve Cleaning

or Replacement" in the "Maintenance" section.

Replace lamp, as it nears its end of life (EOL). See

"Lamp Replacement" in the "Maintenance" section.

Replace lamp. See "Lamp Replacement" in the

"Maintenance" section.

Verify input voltage to purifier.

Have water tested to confirm that it does not exceed

maximum recommended concentration levels for use

with this purifier.