Froth milk and make cappuccino/latte
13. Fill a jug with 100ml (for cappuccino) or 200ml (for latte) milk. Note: make sure jug diameter is no less
than 70±5mm, and jug capacity can hold twice the milk volume after frothed.
14. When pre-heating is done,
blinking. NOTE: Use full milk at refrigerator temperature (NOT HOT!)
15. When the
button stops blinking, steam / milk frothing function is ready. Before frothing milk, push
steam nozzle in the direction of drip tray, turn the knob to
no water coming out, turn off steam function by turning the knob back to horizontal "OFF" position.
16. Immerse steam nozzle in milk about 2cm under the milk surface, turn on the knob. Make sure the steam
nozzle is placed in a position that makes the milk turning in one direction inside the jug from top to
bottom.
17. When the desired level of foam is reached, turn off the knob. Note: Clean steam nozzle with
wet sponge immediately after steam stops generating. Be careful not to get hurt! The pump
automatically stops working after frothing milk for 3 minutes.
18. Pour the frothed milk into the espresso prepared, now the cappuccino/latte is ready. Sweeten to
taste and if desired, sprinkle the froth with a little cocoa powder. NOTE: After frothing milk, you may
immediately make espresso again by pressing
blinking quickly, cool down the boiler and resume brewing (see step 11)
DIY
/
VOLUME
19. When pre-heating is done,
for 3 seconds to start resetting mode. Press
when the desired volume is reached. Now the volume is saved for next operations.
20. Restore factory default setting simply by simultaneously pressing
again.
CLEANING AND CARE
21. Turn the machine off and unplug the power cord. Let the machine cool down completely before
cleaning. Wipe all outer surfaces with a damp cloth. Clean water tank, drip tray and drip grid regularly.
Never use caustic or abrasive cleaners, and never immerse the machine in liquid! NOTE: only the filter
cups are dishwasher safe.
22. Detach the filter handle by turning it clockwise. Scrap coffee residue or used E.S.E pod. Extract the filter
cup from the filter holder, rinse them with clean water and dry thoroughly.
DECALCIFYING
23. Descaling is recommended when all indicators blink 5 times with 5 beeps at the moment machine is
turned on. Descaling warning will repeat 2 more times when you turn on the appliance if you do not
perform descaling or do not cancel by simultaneously pressing
24. Fill the water tank to 300ml level with water and then add the descaling agent (or fill in water
and vinegar 1:1). Use only an environmentally friendly descaling agent and always follow the
manufacturer's instructions. When pre-heating is done,
simultaneously press
buttons are blinking slowly one after another. When descaling completes, the machine will return to
stand-by mode. Perform step 1-4 twice before using the machine.
Enjoy your new Electrolux product!
www.electrolux.com
and
and
buttons fully light up. Press
and
and
buttons fully light up, press and hold
/
and
for 3 seconds to start descaling process, during which
position to release steam until there's
or
button. If both
button to start brewing and press again to stop
and
and
and
and
button, it starts
and
buttons start
/
button
buttons for 3 seconds
and
for 3 seconds.
buttons fully light up,
and
7
EN
EN
CNT
Imprimir página