Electrolux UltimateTaste 500 Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Campana de ventilación Electrolux UltimateTaste 500. Electrolux UltimateTaste 500 23 páginas. High power blender
También para Electrolux UltimateTaste 500: Libro de instrucciones (21 páginas), Libro de instrucciones (24 páginas), Libro de instrucciones (20 páginas), Libro de instrucciones (12 páginas), Libro de instrucciones (16 páginas), Libro de instrucciones (16 páginas), Libro de instrucciones (26 páginas), Manual del usuario (22 páginas), Manual del usuario (16 páginas), Manual del usuario (23 páginas), Libro de instrucciones (24 páginas)

Imprimir página
Electrolux UltimateTaste 500 Manual del usuario
4
www.electrolux.com
• If the appliance is equipped with an Ice maker or a water dispenser,
fill them with potable water only.
• If the appliance requires a water connection, connect it to potable
water supply only.
• The inlet water pressure (minimum and maximum)must be between
1 bar (0,1 MPa) and 10 bar (1 MPa)

2. SAFETY INSTRUCTIONS

2.1 Installation
WARNING!
Only a qualified person must install
this appliance.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Obey the installation instruction
supplied with the appliance.
• Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
• Make sure the air can circulate around
the appliance.
• Wait at least 4 hours before connecting
the appliance to the power supply.
This is to allow the oil to flow back in
the compressor.
• Do not install the appliance close to
radiators or cookers, oven or hobs.
• The rear of the appliance must stand
against the wall.
• Do not install the appliance where
there is direct sunlight.
• Do not install this appliance in areas
that are too humid or too colds, such
as the construction appendices,
garages or wine cellars.
• When you move the appliance, lift it
by the front edge to avoid scratching
the floor.
2.2 Electrical connection
WARNING!
Risk of fire and electrical shock.
• The appliance must be earthed.
• All electrical connections should be
made by a qualified electrician.
• Make sure that the electrical
information on the rating plate agrees
with the power supply. If not, contact
an electrician.
• Always use a correctly installed
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to the
electrical components (e.g. mains plug,
mains cable, compressor). Contact the
Service or an electrician to change the
electrical components.
• The mains cable must stay below the
level of the mains plug.
• Connect the mains plug to the mains
socket only at the end of the
installation. Make sure that there
is access to the mains plug after the
installation.
• Do not pull the mains cable to
disconnect the appliance. Always pull
the mains plug.