Electrolux WHGL9040CN Manual - Página 6

Navegue en línea o descargue pdf Manual para Campana de ventilación Electrolux WHGL9040CN. Electrolux WHGL9040CN 21 páginas.
También para Electrolux WHGL9040CN: Manual (40 páginas), Manual de instalación (12 páginas), Manual de instalación (12 páginas)

Imprimir página

www.electrolux.com

4. CONTROLS

Button

5. LIGHTING

Warning: This appliance is fitted with a

white LED lamp classed as 1M according

to EN 60825-1: 1994 + A1:2002 + A2:2001

standards; maximum optical power emitted

@439nm: 7µW. Do not look directly at the light

through optical devices (binoculars, magnifying

glasses...).

• For replacement contact technical support.

("To purchase contact technical support").

L T1 T2 T3 T4 T5 F

Basic function

Dual Function

Press briefly to turn the lighting system on and off.

Press and hold the button for 2 seconds to activate the lighting

system in "courtesy light" mode. The lights are lit at a reduced power

of approximately 5W. This function can be disabled by pressing the

button once again for 2 seconds or by pressing it briefly to switch to

normal lighting mode.

Turns the motor off from whatever speed it is set to.

Press and hold the button for 3 seconds with all the loads turned off

(Motor and Lights), to turn the Activated Charcoal Filter alarm on/off.

Turns the motor on at speed one.

When pressed briefly, turns the motor on at speed two.

Press and hold the button for approximately 2" to turn the Delay

function on and off, that is to say to turn the appliance off after a 20

minute delay. Suitable to complete elimination of residual odours. Can

be activated from the OFF position and from speeds 1, 2, 3. Cannot

be activated with Intensive speed On.

Turns the motor on at speed three.

Turns the motor On and Off at Intensive speed for a timed

period of 5 minutes. At the end of the 5 minutes the appliance

will automatically return to the speed that was set before. If the

appliance was turned off at the time of activation, at the end of

the 5 minutes the system will return to speed one.

Press and hold for 4 seconds to reset the filter alarm indicator,

shown by flashing of button T1. This procedure can only be

carried out with the motor off.

Indicator lights

Button off

Lights off

Button lit

Lights on

Button lit

Courtesy light on

Button lit

Motor active

Motor inactive

Button flashes twice F – Alarm On.

Button flashes once F – Alarm Off.

Button on

Speed two on

Buttons flashing

(T1+T2 or T3

Delay functionActive

or T4)

Button on

Signals the Metal Grease Filter

saturation alarm, indicating that it is

necessary to wash the filters. The

Button on

alarm is triggered after the Hood

has been in operation for 100

working hours.

When this is activated, it

signals the Activated Charcoal

Filter saturation alarm, indicating

that the filter must be changed;

the Metal Grease Filters must

Button flashing

also be washed. The Activated

Charcoal Filter saturation alarm

comes into operation after the

Hood has been working for

200 hours.