Bosch 6 Series Manual de instrucciones - Página 5

Imprimir página

Risk of electric shock!

A defective appliance may cause electric

■

shock. Never switch on a defective

appliance. Unplug the appliance from the

mains or switch off the circuit breaker in

the fuse box. Contact the after-sales

service.

Incorrect repairs are dangerous. Repairs

Risk of electric shock!

■

may only be carried out and damaged

power cables replaced by one of our

trained after-sales technicians. If the

appliance is defective, unplug the

appliance from the mains or switch off the

circuit breaker in the fuse box. Contact the

after-sales service.

Do not use any high-pressure cleaners or

■

Risk of electric shock!

steam cleaners, which can result in an

electric shock.

Environmental protection

Your new appliance is particularly energy-efficient. Here you

can find tips on how to save even more energy when using the

appliance, and how to dispose of your appliance properly.

Saving energy

During cooking, ensure that there is a sufficient supply of air

■

so that the extractor hood can work efficiently and with a low

level of operating noise.

Adjust the fan speed to the intensity of the cooking fumes.

■

Only use intensive mode where this is required. A lower fan

speed means that less energy is consumed.

If there are intensive cooking fumes, select a higher fan

■

speed in good time. If cooking fumes have already spread in

the kitchen, the extractor hood must be operated for longer.

Operating modes

This appliance can be used in exhaust-air mode or circulating-

air mode.

Exhaust air mode

The air which is drawn in is cleaned by the

grease filters and conveyed to the exterior

by a pipe system.

Note: The exhaust air must not be conveyed into a functioning

smoke or exhaust gas flue or into a shaft which is used to

ventilate installation rooms which contain heat-producing

appliances.

Before conveying the exhaust air into a non-functioning

■

smoke or exhaust gas flue, obtain the consent of the heating

engineer responsible.

If the exhaust air is conveyed through the outer wall, a

■

telescopic wall box should be used.

Causes of damage

Caution!

Risk of damage due to corrosion. Always switch on the

appliance while cooking to avoid condensation. Condensate

can produce corrosion damage.

Always replace faulty bulbs to prevent the remaining bulbs from

overloading.

Risk of damage due to ingress of humidity into the electronic

circuitry. Never clean operator controls with a wet cloth.

Surface damage due to incorrect cleaning. Clean stainless

steel surfaces in the direction of the grain only. Do not use any

stainless steel cleaners for operator controls.

Surface damage due to strong or abrasive cleaning agents.

Never use strong and abrasive cleaning agents.

Risk of damage from returning condensate. Install the exhaust

duct in such a way that it falls away from the appliance slightly

(1° slope).

Switch off the extractor hood if you no longer require it.

■

Switch off the lighting if you no longer require it.

■

Clean and, if required, replace the filter at regular intervals in

■

order to increase the effectiveness of the ventilation system

and to prevent the risk of fire.

Environmentally-friendly disposal

Dispose of packaging in an environmentally-friendly manner.

This appliance is labelled in accordance with

European Directive 2012/19/EU concerning used

electrical and electronic appliances (waste electrical

and electronic equipment - WEEE). The guideline

determines the framework for the return and recycling

of used appliances as applicable throughout the EU.

Circulating-air mode

The air which is drawn in is cleaned by the

grease filters and an activated carbon filter and

conveyed back into the kitchen.

Note: To bind odours in circulating-air mode, you must install

an activated carbon filter. The different options for operating the

appliance in circulating-air mode can be found in the brochure.

Alternatively, ask your dealer. The required accessories are

available from specialist outlets, from customer service or from

the Online Shop. The accessory numbers can be found at the

end of the instructions for use.