Bosch 6 Series Manual de instrucciones - Página 10

Imprimir página

Caution!

When lifting the inner panel, the middle panel may stick to the

inner panel. Make sure that the middle panel does not fall.

Remove the inner panel.

Remove the middle panel.

Note: The middle panel is kept in place with rubber bushings

rather than retaining pins.

Clean the panels with glass cleaner and a soft cloth.

Risk of injury!

Scratched glass in the appliance door may develop into a

crack. Do not use a glass scraper, sharp or abrasive cleaning

aids or detergents.

Fitting the door panels

Reinsert the middle panel.

Notes

If the Low-E symbol can be read, the middle panel is

■

inserted correctly.

Make sure that the panel is seated correctly. All rubber

■

mounts must lay flat against the outer panel.

Reinsert the inner panel.

Note: All four fastening pins must engage in the holders

provided for them.

Remove the locking pins and close the oven door.

Removing and fitting the appliance door

If the oven is very heavily soiled, the oven door can be removed

for easier cleaning. Normally, however, this is not necessary.

Removing the appliance door

Open the oven door fully.

Lock both hinges on the left and right using the locking pin

(a).

Note: The locking pins must be fully inserted into the holes in

the hinges.

Grip the oven door on either side with both hands and close

the oven door by approx. 30° (b).

Raise the oven door slightly and pull it out.

Note: Do not fully close the oven door. The hinges could

become bent and the enamel could be damaged.

Fitting the appliance door

Grip the oven door on either side with both hands.

Slide the hinges into the slots in the oven (a).

Note: The notch below the hinges must engage into the

frame of the oven (b).

Lower the door downwards.

Remove the locking pins.

Risk of injury!

Do not reach into the hinge if the oven door falls out

unintentionally or a hinge snaps closed. Call after-sales service.