Bosch 6 Series Manual de instrucciones - Página 21

Imprimir página

Cleaning

How do I clean the hob?

Using a special glass-ceramic cleaning agent produces the best results. We advise against using harsh or abrasive cleaning agents, dish-

water detergent (concentrated) or scouring pads.

You can find more information on cleaning and caring for your hob in the section on ~ "Cleaning"

3Trouble shooting

U sually, faults are small matters that are easy to

T r o u b l e s h o o t i n g

eliminate. Please read the information in the table

before calling the after-sales service.

Display

None

The displays flash

The

indicator flashes in the

hotplate displays

"ƒ

"...

"†

+ heat setting and acous-

tic signal

"†

and acoustic signal

"‚

"‡

"‰

"Š‹‹‹

"Š‹‚‹

—...‹‹

Do not place hot pans on the control panel.

Notes

appears on the display, press and hold the

■

button for the relevant cooking zone in order to read

the fault code.

If the fault code is not listed in the table, disconnect

■

the hob from the mains power supply and wait

30 seconds before reconnecting it. If this code is

displayed again, contact the technical after-sales

service and specify which fault code has appeared.

If a fault occurs, the appliance will not switch to

■

standby mode.

Possible cause

The power supply has been disconnected.

The device has not been connected in accord-

ance with the circuit diagram.

Electronics fault.

The control panel is damp or an object is cover-

ing it.

A fault has occurred in the electronics.

The electronics have overheated and have

switched off the corresponding hotplate.

The electronics have overheated and have

switched off all hotplates.

There is a hot pan in the area of the control

panel. There is a risk that the electronics will

overheat.

There is a hot pan in the area of the control

panel. To protect the electronics, the hotplate

has been switched off.

The hotplate has overheated and switched itself

off to protect the work surface.

The hotplate was operating for an extended

period without interruption.

The supply voltage is faulty; outside of the nor-

mal operating range.

The hob is not connected properly

Solution

Use other electrical devices to check whether a short-circuit has

occurred in the power supply.

Ensure that the device has been connected in accordance with

the circuit diagram.

If the fault cannot be eliminated, inform the technical after-sales

service.

Dry the control panel or remove the object.

To acknowledge the fault, cover the control panel with your hand.

Wait until the electronics have cooled down sufficiently. Then

touch any symbol on the hob.

Remove the pan. The fault display goes out shortly afterwards.

You can continue to cook.

Remove the pan. Wait for a few seconds. Touch any control. If the

fault display goes out, you can continue to cook.

Wait until the electronics have cooled down sufficiently and

switch the hotplate on again.

The automatic safety switch-off function has been activated. See

section

Contact your electricity provider.

Disconnect the hob from the power supply. Ensure that it has

been connected in accordance with the circuit diagram.

Trouble shooting