Bosch 8 Series Manual del usuario e instrucciones de instalación - Página 18

Imprimir página

Bosch 8 Series Manual del usuario e instrucciones de instalación

en Installation instructions

WARNING ‒ Risk of electric shock!

If the insulation of the power cord is dam-

aged, this is dangerous.

▶ Never let the power cord come into contact

with hot appliance parts or heat sources.

▶ Never let the power cord come into contact

with sharp points or edges.

▶ Never kink, crush or modify the power

cord.

WARNING ‒ Risk of injury!

The drawer may open suddenly during trans-

port.

▶ Transport the appliance in such a way that

the drawer does not accidentally open.

Sharp-edged parts may be accessible during

installation.

▶ Wear protective gloves.

ATTENTION!

When the door is opened, the appliance may

tip over.

▶ Above the appliance, provide a fixed inter-

mediate floor in the fitted unit.

▶ When combined with an oven, provide a

fixed intermediate floor above the oven.

21.6 Installation

Fitted units

This is where you can find information about safe in-

stallation.

ATTENTION!

Covering the ventilation slots and air intake openings

causes the appliance to overheat.

Do not cover ventilation slots and air intake open-

▶

ings.

If the appliance is installed behind a decorative panel,

this may cause it to overheat.

Do not install the appliance behind a decorative

▶

panel.

When the door is opened, the appliance may tip over.

Above the appliance, provide a fixed intermediate

▶

floor in the fitted unit.

When combined with an oven, provide a fixed inter-

▶

mediate floor above the oven.

The built-in unit must not have a rear panel behind the

appliance.

Combining with other appliances

You can combine the warming drawer with a maximum

of one more appliance from the same appliance series.

No intermediate floor is required between the appli-

ances.

When installing appliances under an oven, combi-

steam oven or steam oven, no tilt protection is re-

quired.

When installing under the fully automatic coffee ma-

chine, install the tilt protection for the fully automatic

coffee machine.

For the following combinations, install tilt protection on

the warming drawer:

¡ Warming drawer separately, including when in-

stalling below an intermediate floor

¡ Warming drawer underneath a microwave

¡ Warming drawer underneath a hob

¡ Warming drawer with warming drawer, at least on

the upper appliance

¡ Warming drawer with accessories drawer, at least

on the upper appliance

¡ Warming drawer with vacuuming drawer, at least on

the upper appliance

Suitable tilt protection can be obtained from customer

service, on our website or in the online shop.

→ "Fitting tilt protection", Page 18

Fitting tilt protection

Suitable tilt protection (order number: 12039458) can

be obtained from customer service, on our website or

in the online shop.

Measure a clearance of 518 mm from the front

edge of the unit and mark it on both sides in the fit-

ted unit.

Screw the two brackets into the elongated hole on

the mark.

Place the appliance on a flat surface.