Electrolux Beam Manual de instalación - Página 13

Navegue en línea o descargue pdf Manual de instalación para Aspiradora Electrolux Beam. Electrolux Beam 16 páginas. Central

GLUE -

Once you are happy with the layout of your pipework, the joints between

the pipe and fittings (t-pieces, sweep 90° bends, couplers etc) need to be

sealed.

The pot of glue that will be included in the starter inlet kit is similar to a

nail varnish bottle - the lid comes off with a round sponge attached (rather

than a brush).

Get rid of any excess glue from the sponge

Swipe the sponge around the tip of the PIPE to be inserted into a fitting.

Immediately push the pipe into the fitting until it reaches the stop-

ridge inside the fitting

Start the next joint as soon as you want

The 120ml pot of glue should last for about seven inlet kit's worth of

fittings before you would need to contact us to purchase another pot.

Pipe

F YOU PUT THE GLUE INSIDE THE FITTING AND THEN PUSHED THE PIPE INTO THE

FITTING

GLUE WILL BE PUSHED OUT WHERE IT WILL HARDEN INTO AN OBSTRUCTION

INSIDE THE PIPEWORK AND COULD THEREFORE CAUSE A

SWIPE THE GLUE ON THE

RULE 3

SEALING THE JOINTS

Glue Sponge

PIPE

NOT

AND

Stop-ridge of Fitting

BLOCKAGE. P

THE

ITTING

LEASE FIRST