Atlas GSS-G Instrucciones y manual de instalación
Navegue en línea o descargue pdf Instrucciones y manual de instalación para Altavoces Atlas GSS-G. Atlas GSS-G 2 páginas. Garden speaker
Imprimir página
Key Features
•
D ownward Firing Speaker Will Not Collect Dust or Condensation
•
R ugged Construction Can Support Up To 250 lbs
•
E asy Bayonet Attachment of Head Unit To Base, Enables Installation
of Base During Excavation and Installation of Head Unit After
Landscaping Has Been Completed
•
Switch Selectable 70V Input or Direct 8Ω Input (Transformer Bypass)
•
E asy Conduit Installation in Tall and Short Base With Dedicated
Mounting Pads
•
S peaker Protected By Triple Layer Grille
•
S hort Base (GSS-G) has Drill Points for 4" Square, 2-Gang EO Box, or
1-Gang Box Mounting to a Deck or Slab
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
GSS-G & GST-G
Garden Speaker
Instructions
To Install GST-B Tall Base Unit:
1. M ake sure you have a path to bury wire connected to speaker.
2. D ig a hole 8" deep x 30" diameter.
3. R un wire to hole.
4. A ttach conduit or gland nut to flats on base.
5. B ring in wire and leave sufficient cable for adequate service loop
6. F ill base with clean dirt or sand to within 2"-3" of top for optimum
7 .
8. B ack fill dirt to base. Top of base should be 2" – 3" above ground.
To Install GSS-G Short Base Unit:
If Using an EO Box:
1. I nstall 1-Gang, 2-Gang, or 4" x 4" box flush to mounting surface.
2. C ut out scribed line on bottom of base for 1- or 2-gang box.
3. D rill appropriate holes in base (outer 4 holes for 4" x 4", inner 4 for
4. I nstall wiring in box.
5. S et base on box and attach with screws.
GSS-G
If Using Conduit:
Short Base
1. M ount base to surface with appropriate screws through the base
2. A ttach conduit and bring in wire. Provide for surface loop
3. C over with provided temporary lid and attach with provided 1" screws
GST-G
Tall Base
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
(minimum 18") to reach head unit.
bass performance.
C over with provided temporary lid and attach with provided
1" screws if head unit is not to be attached immediately.
2-gang, or 1 set of 2 inner for 1-gang).
bottom.
(minimum 18").
if head unit is not to be attached immediately.
1/2
AtlasSound.com