Atlas Diane Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Ventilador Atlas Diane. Atlas Diane 9 páginas. Ceiling mounted oscillating directional fan ac 120v. 60hz
Imprimir página5 C. Wooden Blade Head: If your fan is one
with wooden blade head, attach your blades as
the last step in the assembly process. Do not
attach them now. Attach them in step No.: 9.
Handle your blade head carefully otherwise you
will bend the blade irons and cause your fan to
vibrate when in use.
6. Loosen the two set screws from the top
coupling of the motor assembly. (Fig. 8)
7. Carefully feed the fan wires up through the
down rod. Thread
the down
coupling then tighten the set screws using the
Allen wrench.(Flg. 8) Carefully reinstall hanger
ball onto rod being sure that cross pin is in
correct position, the set screw on hanger ball is
tight and wires are not twisted.
8. Now lift the motor assembly into position and
place the hanger ball into the hanger bracket.
Rotate until the "Check Tab" has dropped into
the "Registration Slot" and seats firmly. The
entire motor assembly should not rotate if this
is done correctly.
9. Remove protective plastic sleeve from the
motor shaft and attach your wooden blades.
Ignore this step if you have metal blades, as
tfley should already have been installed. Make
sure that the set screw in the blade hub is
counter-sunk into the bore-hole into the shaft of
the motor.
MAKING THE ELECTRICAL
CONNECTIONS
Warning:
The power should have already
been disconnected.
Follow the steps below to
connect the fan to your household wiring. Use
the wire nuts supplied with your fan. Secure
the wire nuts with electrical tape. Make sure
there are no loose strands or connections.
NOTE: The Hand Held Remote Control units
included with your ceiling fan are equipped
with 16 code combinations to prevent possible
interference from or to other remote units. The
frequency
switches
on your Receiver
Transmitter
units have been preset at the
factory. Please re-check to make sure the
switches on both units are set to the same
positions. The frequency settings should be
changed only in case of interference or if a
second or more remote controlled ceiling fans
are installed in the same room. Any code
combination will operate the ceiling fan and
light as long as the Receiver and Transmitter
units are set to the same codes (Fig. 10)
1. Insert Receiver into Hanger Bracket with
the flat side of the Receiver facing the ceiling.
(Fig. 11)
rod into the
and
5
Figure 9
(~)
.'
'.
Figure 10
Figure 11