Alert 750R Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Arranque a distancia Alert 750R. Alert 750R 15 páginas. Remote engine starter with alarm system

Imprimir página

G. TEMPERATURE CHECK

You can monitor through the LCD screen, the present indoor temperature of the

passenger compartment before cooling or heating your vehicle.

Press the transceiver

in-door temperature will be shown on the LCD screen. This reading may be higher than

actual ambient temperature due to the greenhouse and is relative only the inside vehicle

temperature.

H. TO TURN OFF THE REMOTE START:

When the engine is running (by remote start), if you want to stop it,

1. Press

button twice on the remote transmitter under remote start mode.

2. Move the optional remote start enable toggle switch to OFF position. (If installed)

3. Press the brake pedal

4. Pull down the hand brake. (for Standard Transmission Gear Vehicle)

The vehicle will shut down and turn off the parking light to indicate engine stopped.

I. SHUT-DOWN INPUT FOR REMOTE STARTER:

If any of the following conditions exist while the system is operating, the engine will not start or will shut

down immediately:

1. The hood is opened.

2. The brake pedal is pressed.

3. The hand brake is released (for Standard Transmission Gear Vehicle)

4. Engine is over-revved. {"Tachometer checking type" only}

5. The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.

6. Press

button twice on the remote transmitter under remote start mode .

7. Move the optional remote start enable toggle switch to OFF position. (If installed)

8. The vehicle refused to start running after {3} unsuccessful attempts.

J. DISABLING THE REMOTE START SYSTEM:

This feature allows your system's remote start unit to be temporarily disabled to prevent the vehicle from

being remote started accidentally. This feature is useful if the vehicle is being serviced or stored in an

enclosed area. To disable the remote start, move the optional remote start enable toggle switch to the

OFF position.

Note: If the system is interfered by stronger radio frequency around, sources of high voltage electric power

or such Obstacles like tall buildings and so on, the transmission range may get shorter as the system

uses low out put powered frequency.

A. BATTERY REPLACEMENT:

A 1.5V type AAA Alkaline battery powers the Remote Transceiver. When the power of the battery

weakens a

icon shall be displayed on the LCD screen. When the old battery is replaced to new one,

there will be beep sounds indicate the power is up and the clock on the LCD screen returns to AM12:00

after displaying all the icons. Correct the time by pressing

750R OP

button first, within 3 seconds press the

LCD REMOTE TRANSCEIVER

( )

(If installed)

for 3 seconds before using (See Timer

MAY/03/2004

button; the