Bose Acoustimass 20 Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Altavoces Bose Acoustimass 20. Bose Acoustimass 20 22 páginas. Powered speaker system
También para Bose Acoustimass 20: Manual del usuario (22 páginas)

Imprimir página

Connect

the speakers

and the Acoustimass

_ module

Connecting

the Acoustimass

20 Jewel

Cube _ speakers

to the

Acoustimass

module

1. Insert the connector of each speaker cable fully into the jack on the rear of each speaker

(Figure 5). Match the ridge of the connector to the notch at the top of the jack.

2. Connect each 20-foot (6.1 m) cable to the corresponding left or right green jack on the

Acoustimass module. Speaker cables have green connectors at one end, with L (left) and

R (right) molded into the connectors.

To extend the length of speaker cable, you will need a 30-foot extension cable. To order this

part, please call Bose_'customer service (request PN 186445-1 black; PN 186445-2 white).

Or, splice in 18-gauge (.75 mm 2)or thicker cord (connecting + to + and -to -). To purchase

extension wire, see your dealer, electronics store, or call Bosecustomer

service.

Figure

Speaker cable connec_ns

the Jewel Cube speaker array

Figure

Speaker cable connections

the cube speaker array

Connecting

the Acoustimass

5 cube

speaker

arrays

to the

Acoustimass

module

Each speaker cable contains two wires. The wire marked with a red collar is positive (+) and

the ribbed one is negative (-). These wires match the positive (red) and negative (black)

terminals on the back of each speaker. To extend the length of speaker cable, you will need a

30-foot extension cable. To purchase this cable see dealer, electronics store, or call Bose

customer service. To order this part from Bose, please call Bose customer service (request

PN 186445-1 black; PN 186445-2 white). Or, splice in 18-gauge (.75 mm 2)or thicker cord

(connecting + to + and -to -).

Match the correct cable to the corresponding speaker location.

• Speaker cables have blue connectors at one end, with L and R molded into the

connectors.

• The red collars on the + wire are labeled LEFT and RIGHT.

Connect the wire end of one speaker cable to the terminals on the rear of the matching

cube speaker array.

a. Press the terminal tab on the back of the cube array to insert the marked wire into the

red terminal and the plain wire into the black terminal. Release the tab to secure the

wire.

b. Repeat this step for each of the cube speaker arrays (see Figure 6).

3. Connect each cable to the corresponding left or right blue jack on the Acoustimass

module.

CAUTlON:

Make sure no strands of wire from any terminat touch any other terminaL Bridged

wires create short oircuits that affect proper operation of your system.

AM262838

00 !Zpdf

December20,

2001