Bose Acoustimass-20 Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Altavoces Bose Acoustimass-20. Bose Acoustimass-20 22 páginas. Powered speaker system

Imprimir página

Connecting

the Acoustimass

module

to multi.room

interface

systems

Figure

Connecting me speakers to

your multi room interface

.VAR

Note:

To extend the length of the cables, use the supplied 50-foot extension cable (shown

in the dotted line above). This cable connects between the 30-foot audio input cable and the

3-foot VAR adapter cable.

To connect the Acoustimass 5 or 20 powered speakers to your system, follow these steps:

1. Using the supplied 30-foot audio input cable, insert the round DIN connector into the

Acoustimass module, and the RCA plugs into the supplied 3-foot VAR adapter cable

labeled VAR on the single-connector end.

2. Attach the single-connector end of the 3-foot VAR adapter cable to one of the unused

ROOM output jacks (B, C, D) on the rear of the multi-room interface (Figure 11).

Connecting

power

to your

system

CA UTION

If you purchased a dual-voltage system, it is important that you set the speakers

to the correct voltage. To do this, refer to "Selecting the correct voltage" on page 6.

Follow these steps to connect power to your Acoustimass powered speaker system:

1. Plug the power cord from the Acoustimass module into an AC power (mains) outlet.

2. Insert the power cord of the Lifestyle' system into an AC power (mains) outlet.

3. Turn the Acoustimass module power switch to the On position.

Operating

in more

than

one

room

Your Lifestyle' system Personal' music center can control up to four sets of Bose powered

speakers, allowing your family to enjoy four different audio sources (CD, radio, TV, etc.) in up

to four rooms. These rooms are referred to as room A, B, C, and D, with room A being the

primary room (the one used for a one-room system). If two or more rooms are connected to

your system, the Personal music center displays ROOM and HOUSE buttons, and room

indicators (A, B, C, and/or D). Figure 12 shows a sample display for a two-room system.

Note_o

not plug the AC power pack into a power Outlet until all Component Connections

are complete.

AM26283S

O0 !Zpdf

December 20, 2001