Atlas Copco D2160-Q Instrucciones del producto - Página 11

Navegue en línea o descargue pdf Instrucciones del producto para Taladro Atlas Copco D2160-Q. Atlas Copco D2160-Q 20 páginas. Straight drill

D2160-Q

Brand

Mobil

Klüber Lub.

Texaco

Molykote

Maintenance and lubrication

The throttle valve, planetary gears, needle bearings and ball bearings must be lubricated with grease

when the tool is dismantled at the regular maintenance. Rhenus LKR03 gives long intervals between lubri-

cations.

Dismantle the motor, see the Dismantling and assembly section.

Clean the motor parts and apply a thin layer of air lubrication oil onto the vanes and inner surface of

cylinder and end plates.

Assemble the motor and make sure that it is running free. Add two drops of oil through the air inlet

and run the motor at idling speed for 5-10 seconds.

The strainer in the adapter should be cleaned regularly to prevent choking which will lead to a loss in ca-

pacity.

WARNING Polymer hazard

The vanes in this product contain PTFE (a synthetic fluoropolymer). Due to wear, there might be

PTFE particles inside the product. Heated PTFE can produce fumes which may cause polymer fume

fever with flu-like symptoms, especially when smoking contaminated tobacco.

Health and Safety recommendations for PTFE must be followed when handling vanes and other com-

ponents:

Do not smoke when servicing this product

►

PTFE-particles must not come in contact with open fire, glow or heat

►

Motor components must be washed with cleaning fluid and not blown clear with an air line

►

Wash your hands before starting any other activity

►

Dismantling

General purpose, Bearings and Gears

Rembrandt EP2

Mobilegrease XHP 222 NLG 2

Klübersynth UH 1 14-151

Multifak EP2

BR2 Plus

Service