Atlas Copco RBU Manual de instalación - Página 3

Navegue en línea o descargue pdf Manual de instalación para Herramientas Atlas Copco RBU. Atlas Copco RBU 8 páginas.

Imprimir página

RBU Installation guide

Original Product instructions

RBU installation guide

General

The RBU, Rapid Backup Unit, is a software key and data storage for the Power Focus Compact

and Graph models. The RBU unlocks a specified amount of the software/functions installed in

the Power Focus. It also stores a back-up copy of the Power Focus configuration, which makes

it possible to move functionality and configurations between different Power Focus units.

There are three different RBU-versions, Bronze, Silver and Gold, where the Gold version un-

locks the full capacity of the Power Focus 4000.

Connecting the RBU

Connect (if not already connected) the RBU to the 15-pin connector on the back panel of the

Power Focus (see figure below). Make sure that the power is switched off when connecting and

disconnecting the RBU. After switching off the power, wait a couple of seconds until the back

lighted TENSOR sign in the centre of the Power Focus front panel is shut off.

Start-up Operating Instructions

At start-up Power Focus behaves differently according to the status of the power Focus and the

RBU memories. For example if the Power Focus and RBU memories do not match, you have to

choose if you want to use the configuration stored in the Power Focus or the RBU. If the power

Focus and the RBU are incompatible for other reasons than configuration mismatch, either the

Power Focus or RBU is referred to (in the table below) as NOK.

On the Compact, press the plus (+) or minus (-) button to toggle between the selections. On the

Graph, press the corresponding soft button to make a selection. Confirm selections with the En-

ter button. The table below describes the different states:

State

Power Focus RBU matches

Power Focus and RBU do not

match

Power Focus OK

RBU NOK

Power Focus NOK

RBU OK

Message at start-up

Compact

No message

"PF"/"RBU"/"STOP"

"PF"/"STOP"

"RBU"/"STOP"

Message at start-up

Graph

No message

"Select PF or RBU"

"Select PF or Stop"

"Select RBU or Stop"

Original Product instructions

Action

----

Select if you want to use the

Power Focus or the RBU con-

figuration.

Select if you want to use the

Power Focus configuration.

Otherwise select "Stop".

Select if you want to use the

RBU configuration. Otherwise

select "Stop".