Atlas Copco CS 14 Manual de instrucciones de seguridad y funcionamiento - Página 6
Navegue en línea o descargue pdf Manual de instrucciones de seguridad y funcionamiento para Equipos de construcción Atlas Copco CS 14. Atlas Copco CS 14 14 páginas. Crawler for christensen core drilling rig
Imprimir página
Safety and operating instructions
Safety area
WARNING Falling objects can cause serious
injury or death
During operation, falling objects from great heights can
cause bodily injury and extensive damage.
Close off the working area.
Before starting always make sure no unauthorized
persons are within the working area of the drill rig in
use.
Immediately stop operation when persons are
present in the danger area.
Make sure that no loose pieces of equipment or
other objects are lying on the feed.
Hoisting and transport
WARNING Heavy equipment can cause serious
injury
Use a sling dimensioned for the load it is to carry.
Use only straps that are whole and intended for the
load in question.
Never use a damaged rope/sling.
Fasten straps in lifting eyes when present.
Always lift at the centre of gravity.
Always make sure that nobody is under or anywhere
near a suspended load or within the swing radius of
the rope/sling.
Observe great care when strapping and lifting heavy
objects.
WARNING Unexpected movement can cause
serious injury
If the rig is left unattended or disconnected from the
transport unit an unexpected movement of the drill unit
can cause serious injury or death
Lock the articulated steering before hoisting
Make sure that the hydraulic jacks are grounded or
wedge the wheels of the carrier
NOTICE
Sling can damage components
When lifting, make sure that the sling will not
damage the hydraulic hoses, mechanical
components etc.
Use a spreader bar to lift the drill unit.
6
Operation, precautions
WARNING Hydraulic oil at high pressure
Thin jets of hydraulic oil under high pressure can
penetrate the skin and cause permanent damage.
Immediately consult a doctor if hydraulic oil has
penetrated the skin.
Never use your fingers to check for hydraulic fluid
leaks.
Keep your face away from any possible leaks.
WARNING Dust hazard
When drilling with compressed air, the rock cuttings
are carried out of the bore in the form of small cuttings,
and dust, which can cause serious injury.
Some dusts, fumes or other airborne material created
during use of the machine may contain chemicals
known to the state of California to cause cancer
and birth defects or other reproductive harm. Some
examples of such chemicals are:
Crystalline silica, cement and other masonry
products.
Arsenic and chromium from chemically-treated
rubber.
Lead from lead-based paints.
To reduce your exposure to these chemicals, work in
a well ventilated area and work with approved safety
equipment, such as dust masks that are specially
designed to filter out microscopic particles .
Use a dust collector, or spray water with a water/
foam pump.
WARNING Heavy equipment can cause serious
injury
Make sure that the drill is anchored to withstand the
set forces.
Make sure that the rig is stable before starting to
drill.
WARNING Unexpected movement can cause
serious injury
If control levers and switches are not set to neutral
position, start of the machine can lead to unexpected
movements and can therefore cause injury.
Set control levers and switches to the neutral
positions prior to starting up.
WARNING Noise hazard
High sound levels may cause permanent hearing loss.
Use hearing protection in accordance with
occupational health and safety regulations.
WARNING Compressed air
When drilIing with compressed air, the rock cuttings
are carried out of the bore in the form of small cuttings,
© 2010 Atlas Copco Craelius AB | 2010-06-18
02 Safety Instructions CS14C Ed.0