Bose Acoustimass 16 Series II Manual del usuario - Página 9
Navegue en línea o descargue pdf Manual del usuario para Sistema de altavoces Bose Acoustimass 16 Series II. Bose Acoustimass 16 Series II 44 páginas. Home entertainment speaker system
También para Bose Acoustimass 16 Series II: Manual del usuario (33 páginas), Manual de configuración rápida (1 páginas), Manual del usuario (24 páginas)
Imprimir página
English
Español
Figure 6
System input cable
connectors
Figure 7
Unzipping the paired wires
Français
Connecting the Acoustimass
The system input cable is 20 feet (6.1 meter) long and connects the Acoustimass module to
your surround sound receiver. Unlike the speaker cables, this input cable has a multi-pin !
connector that inserts into the Audio Input jack on the module (Figure 6).
Module input jack
cable connector
At the other end of the system input cable, multiple wire pairs that "unzip" for easy reach and
insertion into terminals on your receiver (Figure 7). A red collar marks a wire as positive (+).
CAUTION: Do NOT connect your module to the TV, which lacks the required amplification.
The single RCA connector at that end is for use ONLY with a receiver that handles !
low-frequency effects and provides an LFE/SUBWOOFER jack (Figure 7).
RCA
connector
for LFE
only
CAUTION: Before making these connections, turn off your receiver to prevent unwanted noises
when you plug the Acoustimass
To make the connections (Figure 8 on page 10):
1. Insert the multi-pin connector on the system input cable into the input jack on the !
Acoustimass module. Tighten the two thumbscrews to secure the connection.
2. Connect each wire pair on the other end of the system input cable to your surround
receiver, which should have audio output terminals labeled:
• Right, Left, Center for the front audio channels
• Right Surround, Left Surround, and possibly Center Surround for the rear channels. !
The specific labels on your receiver may differ slightly.
CAUTION: Do not allow exposed wires to brush against each other; this could damage your
receiver.
3. Carefully match the polarity of the connections (+ to + and – to –).
• Attach each red-collared wire (+) to the appropriate + terminal.
• Attach each plain wire (–) to the appropriate – terminal.
4. If applicable to your receiver, insert the RCA plug marked LFE on the system input cable
into the LFE/SUBWOOFER OUT jack on your surround receiver. Remove the cover first.
®
module to the receiver
System input
Wire pair
®
module into it.
S
U
ETTING
P
9