Atlas Copco 8431026931 Instrucciones del producto - Página 11

Navegue en línea o descargue pdf Instrucciones del producto para Destornillador eléctrico Atlas Copco 8431026931. Atlas Copco 8431026931 20 páginas.

LUM12 HRF

Service

Preventive maintenance is recommended at regular intervals. See the detailed information on preventive

maintenance. If the product is not working properly, take it out of service and inspect it.

If no detailed information about preventive maintenance is included, follow these general guide-

lines:

■

Clean appropriate parts accurately

■

Replace any defective or worn parts

Overhaul and preventive maintenance is recommended at regular intervals once per year or after maxi-

mum 250.000 tightening depending on which occurs sooner. More frequent overhaul may be needed, if

used at high torque and long tightening times. If the machine not is working properly, it should immediately

be taken away for inspection.

The strainer at the air inlet and the exhaust silencer should be cleaned frequently or replaced in order to

prevent clogging, which decreases the capacity.

At the overhauls, all parts should be cleaned accurately and defective or worn parts (i.e. O-rings, vanes)

should be replaced.

Cleaning

Clean all parts thoroughly in white spirit or similar cleaning agent. To prevent clogging and decreased

power, it could be necessary to clean the strainer (if used) and the exhaust filter between the overhauls.

Inspection

After the cleaning, inspect all parts. Damaged and worn parts should be replaced.

Parts without ordering number are for technical reasons not delivered separately. The use of other gen-

uine Atlas Copco replacement parts may result in decreased tool performance and increased mainte-

nance and may, at the company option, invalidate all warranties.

The tightening torques indicated in the exploded views list in ServAid (see Spare parts section in

servaid.atlascopco.com) are established to achieve the correct clamping force and prevent the parts from

coming loose.

When servicing these parts, they must be able to open up without being destroyed. In special circum-

stances (depending on application and usage) the parts may however come loose after some time of op-

eration. In such cases the torque can be increased by 10-20%. If necessary, a low or medium threadlock-

ing fluid can also be applied.

Service

https://