3M G5 Manual - Página 6

Navegue en línea o descargue pdf Manual para Auriculares 3M G5. 3M G5 10 páginas. Drive-thru systems
También para 3M G5: Manual de consulta rápida (2 páginas), Boletín técnico (6 páginas), Boletín técnico (2 páginas), Manual de inicio rápido (3 páginas), Boletín técnico (12 páginas), Manual (8 páginas)

4. Install Vehicle Detector Board and any External Antennas.

Installing Vehicle Detector Boards

G5 Basestation accommodates up to TWO vehicle detector boards and these MUST be connected to the Order Point induction loops.

Follow the procedure below to install them into the G5 basestation.

Align the bottom of the vehicle detector board with

the installation slot.

Slide the top edge of the board between the back

of the base station and the two raised tabs.

Install and gently tighten the screw.

Carefully install the three wires between the

vehicle detector board and the base station board.

The left-to-right pin order is the same on both boards:

the left pin on one corresponds to the left pin on the other.

Configure the dip switches, if required, according to the table on the circuit board and your needs .

Installing External Antenna(s)

If the store currently uses an External Antenna (either Omni-Directional or Patch Antenna), it is assumed that the location of the external

antenna is not going to change.

Follow the steps below to re-connect the existing external antenna.

Remove either the left or right antenna on

the G5 Basestation

Connect the pigtail to basestation antenna connector,

in spot where antenna was removed

NOTE: DO NOT use a tool to tighten the pigtail to

the Base Station, leave the connection finger tight.

Connect coaxial cable (of the external antenna) to pigtail.

Dip Switch Settings

G5 Basestation Antenna

Lane 1

Lane 2