Bose Lifestyle 28 Manual de solución de problemas - Página 23

Navegue en línea o descargue pdf Manual de solución de problemas para Sistema de cine en casa Bose Lifestyle 28. Bose Lifestyle 28 32 páginas. Dvd home entertainment systems
También para Bose Lifestyle 28: Manual de instalación (32 páginas), Manual de instrucciones (44 páginas), Manual del usuario (22 páginas), Manual de instrucciones (46 páginas), Manual de instrucciones (44 páginas), Manual de instrucciones (34 páginas)

Imprimir página

Bose Lifestyle 28 Manual de solución de problemas

Placing the Bass Module into TAP Mode

Place all four DIP switches to the down position before returning the unit to the customer

1. Place the bass module into TAP mode

1.1 Set all four DIP switches into the "up"

position. Apply power to the bass module using

the AC line switch and wait until the amber

LED blinks twice and the green LED blinks

briefly at least once (approximately 3 seconds

after power up). Then, within twenty seconds,

flip ALL four switches down, then flip switch #4

(closest to the RJ-45 connector) back up. The

unit will now communicate in TAP mode. The

amber and green LED will blink alternately

when no S/PDIF signal is applied. Note that

when TAP mode is activated in this manner,

the DSP will echo characters sent by the

terminal.

Figure 1. DIP switch Up/Down orientation

Type the equalization setup command

SE [SPEAKER TYPE], [EUROPEAN BASS],

[EUROPEAN TREBLE]

Command

SPEAKER

TYPE

F = falcon

D = doubleshot

C = cricket

B = dublin

M = mariner

U = Installer

Example: To set the equalization to cricket

cubes, euro bass off and euro treble off, type

the command as follows. SE C,OFF,OFF

Down

Equalizer Programming Method

Condition

EURO

BASS

TREBLE

ON/OFF

PS18/28/35 Troubleshooting Guide

2. Verify the bass module communicates in

TAP mode.

2.1 Connect the test cable's, part number

264564, DB-9 connector to the RS-232 COM

port on your computer. Connect the test cable's

RJ-45 connector to the bass module.

2.2 Type the command ST S and hit "Enter".

The following response should be seen on your

computer screen. The results may differ de-

pending on the unit settings. If no S/PDIF

signal is applied, the sample rate will be 29

kHz.

SAMPLE RATE : 44101.30

SPKR TYPE

: 02

DIP VALUE

: 1111

LCRB_MUTE

: 1

LSRS_MUTE

: 1

SAT_CLIP

: 1

BASS_CLIP

: 1

EURO_BASS

: 1

EURO_TREBLE: 0

2.3 Check the software by typing (issuing) the

command TN 4 and then hitting "Enter". A

typical response would be as follows.

03DE6455, 010808

03DE6455 is the checksum

010808 is the software version

Verify the changes have been made by typing

the command ST S.

The speaker type (SPKR TYPE) and other

information will be displayed. Decode the

numerical two digit speaker type as follows.

00 Falcon (Early version dual cube)

01 Doubleshots (Later version dual cube)

02 Cricket (Jewel

Cube)

03 Dublin (Single Cube)

04 Mariner (151 environmental speakers)

05 User EQ (Installer)