Important Safety Instructions
1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Do not use this apparatus near water.
6.
Clean only with a dry cloth.
7.
Do not block any ventilation openings. Install in accordance
with the manufacturer's instructions.
8.
Do not install near any heat sources, such as radiators, heat
registers, stoves or other apparatus (including amplifiers) that
produce heat.
9.
Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
10. Only use attachments/accessories specified by the
manufacturer.
11. Unplug this apparatus during lightning storms or when unused
for long periods of time.
12. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way:
such as power supply cord or plug is damaged; liquid has
been spilled or objects have fallen into the apparatus; the ap-
paratus has been exposed to rain or moisture, does not oper-
ate normally, or has been dropped.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica-
tions. However, this is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, you are encouraged
to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a different circuit than the
one to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications not expressly approved by Bose
Corporation could void the user's authority to operate this
e quipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause unde-
sired operation.
CAN ICES-3(B)/ NMB-3(B)
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with FCC and Industry Canada RF radiation
exposure limits set forth for general population. It must not be co-
located or be operating in conjunction with any other antennas or
transmitters.
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
Antenna grounding
Example of antenna grounding as per National Electrical Code,
ANSI/NFPA 70.
Ground clamp
Electric service
equipment
Product data logger
This system features a product data logger that is designed to help
Bose better understand product usage and performance over time.
The product data logger records certain technical data and usage
history, including but not limited to volume levels, on/off data, user
settings, source inputs, power output, and setup data. We may use
this data to provide you with better service and support on your
system and to improve product design in the future. Special equip-
ment is required to read the data stored by the product data logger
and such data can only be retrieved by Bose if your system is re-
turned to Bose for service or as returned merchandise. The product
data logger does not collect any personally identifiable information
about you and does not record title, genre or other information
about the media content you access while using your system.
Safety Information
Antenna lead-in wire
Antenna discharge unit
(NEC Section 810-20)
Grounding conductors
(NEC Section 810-21)
Ground clamps
Power service grounding electrode
system (NEC ART 250, Part H)
English - 3
Imprimir página