Bose SoundTouch Manual de servicio - Página 37

Navegue en línea o descargue pdf Manual de servicio para Sistema estéreo Bose SoundTouch. Bose SoundTouch 39 páginas. Wireless pedestal
También para Bose SoundTouch: Manual del usuario (33 páginas), Manual del usuario (32 páginas), Manual de inicio rápido (2 páginas), Manual (9 páginas), Manual del usuario (20 páginas), Manual del usuario (32 páginas), Manual de inicio rápido (5 páginas), Manual Start Here (20 páginas), Manual de inicio rápido (2 páginas), Manual del usuario (18 páginas), Manual de inicio rápido (5 páginas), Manual de inicio rápido (2 páginas)

Imprimir página

6. Set Serial Number

6.1 Enter Manufacturing Mode (Procedure 3)

6.2 At the "->" prompt, enter TAP command

"d serial 1 XXXXXXXXXXXXXXXXX".

Where X equals a serial number digit.

6.3 Enter TAP command "d reset" to reboot

into normal mode.

7. Software Version

7.1 "sys ver"

The unit will reply with something similar to

the following, significant digits are bold:

BoseApp version: 2.1.12.12569.366803

epdbuild.rel_2.x.hepdswbld05.2013-09-

12T18:23:09.

8. Factory Default

8.1 Enter TAP command 'sys factorydefault'

Software Update Procedure

Using a Thumb Drive

• Download the update file from the following

URL: http://worldwide.bose.com/downloads/

en/web/soundtouch_updates_usb/page.html.

• Copy the file to a thumb drive.

• Rename the file, if needed, to "Update.stu"

(note the capital U).

• Plug the thumb drive into the SoundTouch

wireless pedestal.

• Connect the unit to power by connecting

the Bose link cable to the back of the Wave

Music System III while holding down the

reset button on the back of the Wi-Fi adapter.

• Wait about 5 minutes for the update to

complete.

•

Remove the thumb drive. Remove and re-

apply power. The software should be up-

dated.

Note: You can verify that the software

updated by opening a Tera Term window

(follow the procedures on pages 31 - 32)

and typing in the command "sys ver"

<enter>. The software version will be

displayed.

TAP COMMANDS

Wi-Fi Update Procedure

To update the wireless pedestal software

over Wi-Fi, follow the below procedure.

Open the SoundTouch

application will look for the system. Once it

locates the system, it will check it for for any

needed updates. If there is an update avail-

able, it will install it automatically.

You will be able to check the sotware version

that is installed by going to explore/settings/

systems and selecting that device. You will

see the software version that is installed as

well as the IP address for it.

application. The