Bose Wave Radio Manual del usuario - Página 4
Navegue en línea o descargue pdf Manual del usuario para Sistema estéreo Bose Wave Radio. Bose Wave Radio 27 páginas. Owner's guide
También para Bose Wave Radio: Manual del usuario (16 páginas), Manual del usuario (20 páginas), Manual del usuario (12 páginas), Manual de configuración rápida (1 páginas), Manual del usuario (26 páginas)
Important Safety Information
18. Use Proper Power Sources – – Plug the product
into a proper power source, as described in the operating
instructions or as marked on the product.
19. Avoid Power Lines – Use extreme care when
installing an outside antenna system to keep from
touching power lines or circuits, as contact with them
may be fatal. Do not install external antennas near
overhead power lines or other electric light or power
circuits, nor where an antenna can fall into such circuits
or power lines.
20. Ground All Outdoor Antennas – If an external
antenna or cable system is connected to this product, be
sure the antenna or cable system is grounded. This will
provide some protection against voltage surges and
built-up static charges.
Section 810 of the National Electrical Code ANSI/NFPA
No. 70 provides informaiton with respect to proper
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna discharge
unit, size of grounding conductors, location of antenna-
discharge unit, connection to grounding electrodes, and
requirements for the ground electrode. Refer to the
antenna grounding illustration on this page.
2b
Antenna grounding
Example of antenna grounding as per National Electrical Code,
ANSI/NFPA 70.
Ground clamp
Electric service
equipment
Note to CATV system installer
This reminder is provided to call the CATV system installer's
attention to Article 820-40 of the NEC (of USA) that provides
guidelines for proper grounding. In particular, it specifies that the
cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as is practical.
Antenna lead in wire
Antenna discharge unit
(NEC Section 810-20)
Grounding conductors
(NEC Section 810-21)
Ground clamps
Power service grounding
electrode system
(NEC ART 250, Part H)