23zero SABER Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Tienda 23zero SABER. 23zero SABER 12 páginas.

SABER USER MANUAL

Fitting to roof rack

The Saber roof top tent must be fitted to roof racks with the hinges facing forward (front of vehicle).

It must be clamped on 4 corners using the 8 x 55mm M8 bolts & mounting plates supplied. To do

this, place the roof top tent on top of the vehicle's roof rack (minimum 4-person lift).

Important: Ensure the Saber is key locked during installation to avoid accidental opening.

The pre fitted mounting rails have 2 channels facing downward, either channel can be used to

mount the Saber roof top tent to the roof rack. Slide 4 x 55mm M8 bolts into either rail. Position

these so there are 2 bolts toward the front of the tent and 2 bolts toward the rear of the tent on

each rail. Lift / tilt the roof top tent to allow the inner bolts to cross over onto the inside of the roof

bars.

Inspect the position of the roof top tent to ensure it will open in the desired position.

Note: It is recommended the rear of the tent is flush with the back of the vehicle to allow correct

ladder angle. Place a mounting plate under the roof bar whilst locating the bolts, insert washer

and hand tighten Nylok nut. Repeat for all 4 corners. Double check the tent's position as desired

and tighten all nuts securely with 13mm spanner. Insert end caps into the ends of the mounting

rails, this may require light taps from a hammer.

Inspections: Roof top tents have many moving parts so maintenance checks are always advised.

During trips regularly check that all the above fixings are tight and in good repair.