Bose Lifestyle 35 Manual de instrucciones - Página 14

Navegue en línea o descargue pdf Manual de instrucciones para Amplificador Bose Lifestyle 35. Bose Lifestyle 35 46 páginas. Dvd home entertainment systems
También para Bose Lifestyle 35: Manual de instalación (32 páginas), Manual de instrucciones (48 páginas), Manual del usuario (22 páginas), Manual de instrucciones (44 páginas), Manual de instrucciones (34 páginas)

General System Operation

You can turn your system on and off using the On/Off button on the remote control or the

media center button panel. When you turn it on with either On/Off button, the source that

was played last is automatically selected. You can also press any source button on the

remote to turn the system on and select the source at the same time.

Volume

System volume can be raised or lowered using the Volume

media center button panel.

Changing the number of speakers playing

When you turn on a source, the number of speakers used for that source is automatically

determined. For example, when you select FM, the front right and left speakers are used.

When you play a DVD video, all ﬁve speakers are turned on. You can change the number of

speakers used for any source by pressing the Speakers 2-3-5 button on the remote control.

Adjusting surround sound

The sound level of the surround (rear) speakers in your system can be adjusted in small steps

using the Surround + / – buttons on your remote. In surround (5-speaker) mode, Surround+

raises the volume; Surround– lowers it.

Using the headphones jack

For private listening, you can connect a headset to the headset jack located on the right side

of the media center. When a headset is connected, all ZONE 1 speakers are muted.

Your system includes a sleep timer which can be set to turn your system off automatically

after 10 to 90 minutes of listening to any source. This timer can be accessed through the set-

tings menu. See "Using the settings menus" on page 21.

If you connected your TV using a standard composite video cable (single cable with yellow

connectors) or an S-video cable, you do not need to change your systems video output set-

ting. However, if you connected your TV or monitor using component video cables, you must

change the video output setting. The component video signals will then be sent out on the

composite and S-video connectors instead of the standard signals. To change the video out-

put setting, see "Changing System Settings" on page 21.

When necessary, the system settings can be changed using the system settings menus. See

"Changing System Settings" on page 21.

October 30, 2001

buttons on the remote or the

AM259776_01_V.pdf