Bose Lifestyle SA-3 Manual - Página 30

Navegue en línea o descargue pdf Manual para Amplificador Bose Lifestyle SA-3. Bose Lifestyle SA-3 34 páginas. Bose stereo amplifier owner's guide sa-2, sa-3
También para Bose Lifestyle SA-3: Manual del usuario (32 páginas), Teoría de funcionamiento (4 páginas)

Imprimir página

Equipment Needed:

•

DC Power Supply

Audio signal generator

•

2 - 6 Ohm, 100 Watt load resistors

•

Audio input cable part number 278128

•

Connector plug part number 272953-04

•

DIP Switch Settings

Set up the unit under test as described below.

1. Set the DIP Switches as described above.

2. Connect the DIN connector of cable part number 278128-001 to the amplifier Bose

input connector.

3. Connect the left and right RCA connectors to a signal generator.

4. Load the left and right outputs with a 6 Ohm, 100W resistor by using connector plug

part number 272953-04.

5. With the unit unpowered apply a 1.6 VDC to PIN 6 of the bottom DIN connector.

Note: The microcontroller will respond by placing the unit in a special test mode. The unit

will power ON (LED will turn to solid green), source channel 2 will be selected, volume

level will be set to maximum and the amplifier outputs will unmute.

6. Apply AC Power.

Note: The 2.5 VDC must be applied before AC voltage is applied.

LED Status Indicator

The green LED, located next to the dip switches on the rear of the unit, indicates the opera-

tional mode of the amplifier.

LED activity

Constant slow blinking

Continuously lit

Lit but rapidly flickering

Blinking Quickly

TEST SET-UP

A Up Stereo/Mono switch (up is stereo mode)

B Down Enable/Disable auto-detect of RCA audio input (up is disabled)

C Down Slave/Master switch (down is master mode)

6 Down Room Address 1

7 Down Room Address 2

8 Down Room Address 3

Up Room Address 4

Mode

Power off (Standby)

Power on

Slave

Receiving commands

bit (MSB)

bit

bit (LSB)

link DIN