Dromida SKYCRUISER2 Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Juguete Dromida SKYCRUISER2. Dromida SKYCRUISER2 8 páginas.

Imprimir página

TROUBLESHOOTING

PROBLEM: Transmitter LED does not illuminate when

tuned on.

Solution: Transmitter batteries are installed incorrectly.

Remove batteries and check polarity markings.

Solution: Transmitter batteries are low. Replace the

batteries.

PROBLEM: The model does not respond to the

transmitter.

Solution: The battery needs to be charged. Charge

the battery.

Solution: The battery is not plugged in to the plane.

Plug it in.

Solution: The control linkages are not connected to

the control surfaces. Inspect and reattach or

replace the parts as needed.

Solution: The plane is not linked to the transmitter;

review and follow the linking procedure.

Solution: The transmitter batteries are low. Replace

the batteries.

PROBLEM: Flight time is short.

Solution: The flight battery was not fully charged. Let

the battery cool and charge again.

Solution: The flying conditions are too cold (below

60°F or 15°C).

Solution: The battery is old or damaged. Replace

the battery.

PROBLEM: The plane has excess vibration.

Solution: The prop is damaged. Replace the prop.

Solution: The motor shaft is bent. Replace the motor.

PROBLEM: The model does not fly straight or level.

Solution: The transmitter trims are not set properly.

Adjust the trims until the plane flies straight

and level.

Solution: Check the control linkages for damage. Repair

or replace parts as needed.

PROBLEM: The motor stops in flight.

Solution: When the flight battery voltage drops too low

the battery power to the motor is stopped.

Control surfaces will still operate for a

controlled landing. Land immediately and

recharge the battery.

company

FCC STATEMENT

FCC ID#: IYF-Dromida Q415

Brand: Dromida

This device complies with part 15 of the FCC rules. Oper-

ation is subject to the following two conditions.

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, in-

cluding interference that may cause undesired operation.

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE

FOR ANY RADIO OR TV INTERFERENCE CAUSED BY

UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.

Any changes or modifications not expressly approved by

the party responsible for compliance could void the user's

authority to operate the equipment.

This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment.

This equipment should be installed and operated with a

minimum distance of 8 inches [20cm] between the radiator

(transmitter) and your body.

This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

KNOW BEFORE YOU FLY

As a new owner of an unmanned aircraft system (UAS),

you are responsible for the operation of this vehicle and

the safety of those around you. Please contact your local

authorities to find out the latest rules and regulations.

In the United States, please visit:

knowbeforeyoufly.org faa.gov/uas

www.hobbico.com/ama-lipo-warning.html

dromida.com

DIDA1050